Elica Hidden 2.0 IXGL/A/90 - Инструкция по эксплуатации - Страница 20

20 

Temperature Alarm 

The hood is equipped with a temperature sensor that activates 
the motor to speed 3 in the case that the temperature in the 
control panel zone becomes too elevated. 
The alarm condition is indicated with the sequential flash of 
the leds 

L1

, 

L2

, 

L3

. 

This condition remains until the temperature falls below the 
alarm threshold. 
You can get out of this mode by pressing key 

1 

or 

2

. 

Every 30” the sensor checks the environmental temperature of 
the control panel zone. 

Maintenance 

Cleaning 

Clean using 

ONLY

 the cloth dampened with neutral liquid 

detergent. 

DO NOT CLEAN WITH TOOLS OR 

INSTRUMENTS

. Do not use abrasive products. 

DO NOT USE 

ALCOHOL! 

Panel 

Fig. 12 
 
Attention! Hold the panel with both hands when 
dismantling and re-mounting in position to avoid it falling 
and causing damage to people or things. 
Dismantling:  

-pull the panel (FRONT SIDE) downward with decision, 
-push to the left the small lever located on the right side of the 

panel,

-unhook it from the back hinges. 

Cleaning: 

Clean the suction panel with the same frequency as the fats 
filter using a cloth soaked in neutral liquid detergents.    
 Avoid the use of products containing abrasives. DO NOT 
USE ALCOHOLS.  

Montage: 

The panel must be hooked at the back and fixed in front fitted 
into the pins for the purpose on the surface of the hood.    

Attention! 

always check that the panel is well fixed in its 

place. 
 

Grease filter 

Fig. 10-13 
Traps cooking grease particles. 

The grease filter

 must be cleaned once a month using non 

aggressive detergents, either by hand or in the dishwasher, 
which must be set to a low temperature and a short cycle.  
When washed in a dishwasher, the grease filter may discolour 
slightly, but this does not affect its filtering capacity. 
To remove the grease filter, pull the spring release handle. 

Charcoal filter (filter version only) 

Fig. 11 
It absorbs unpleasant odours caused by cooking. 

The saturation of the 

charcoal filter

 occurs after more or less 

prolonged use, depending on the type of cooking and the 
regularity of cleaning of the grease filter. 
In any case it is necessary to replace the cartridge at least 
every four months. 
The charcoal filter may NOT be washed or regenerated. 

Circular carbon filter 

Apply one on each side as cover to both the shield grids of the 
motor impeller, then turn clockwise. 
For the disassembly, turn counter-clockwise. 

Replacing lamps 

The hood is equipped with a lighting system based on LED 
technology. 
The LEDs guarantee an optimum lighting, a duration up to 10 
times as long as the traditional lamps and allow to save 90% 
electrical energy. 
 
For replacement, contact the technical service.