Elica EDITH JAZZ/F/50 - Инструкция по эксплуатации - Страница 35

35 

Maintenance 

Before performing any maintenance operation, isolate the 
hood from the electrical supply by switching off at the 
connector and removing the connector fuse.  

Cleaning 

The cooker hood should be cleaned regularly (at least with the 
same frequency with which you carry out maintenance of the 
fat filters) internally and externally.  Clean using the cloth 
dampened with neutral liquid detergent. Do not use abrasive 
products. 

DO NOT USE ALCOHOL!

WARNING: 

Failure to carry out the basic cleaning 

recommendations of the cooker hood and replacement of the 
filters may cause fire risks.  
Therefore, we recommend observing these instructions. 
The manufacturer declines all responsibility for any damage to 
the motor or any fire damage linked to inappropriate 
maintenance or failure to observe the above safety 
recommendations. 

Grease filter 

Fig. 28-29-30 
Traps cooking grease particles. 

This must be cleaned at least once a month (or when the filter 
saturation indication system - envisaged on the model in 
possession - indicates this necessity), using non-aggressive 
detergents, in a dishwasher, which must be set to a low 
temperature and a short cycle (Tmax: 70°C). 
When washed in a dishwasher, metal parts may discolour 
slightly.  
The filter must be dried in an oven for one hour at a max 
temperature of 100°C; if the filter is still moist, repeat the 
operation. 
Replace the filter at least every 2 years. 

Attention!

 After having performed maintenance on the filter, 

FIRST

 install the grease filter in the specific container and 

THEN

 the charcoal filter. The latter can be recognised as it is 

sealed inside a braiding. 

Once the container has been repositioned, make sure only the 
grease filter is visible. 

Charcoal filter (filter version only) 

Fig. 28-29-30 
It absorbs unpleasant odours caused by cooking. 
Attention!

 The active charcoal filter can be recognised as it is 

sealed inside a braiding. Perform disassembly, maintenance 
and cleaning operations of the filter, managing it with the 
utmost care to avoid damaging or opening the braiding. 
The charcoal filter can be washed once every two months (or 
when the filter saturation indication system – if envisaged on 
the model in possession – indicates this necessity)   using hot 
water and a suitable detergent, or in a dishwasher at 65°C (if 
the dishwasher is used, select the full cycle function and leave 
dishes out). 
Eliminate excess water without damaging the filter, then put it 
in the oven for 10 minutes at 100° C to dry completely. 
Replace the mattress every 3 years and when the cloth is 

damaged. 

Attention!

 After having performed maintenance on the filter, 

FIRST

 install the grease filter in the specific container and 

THEN

 the charcoal filter. The latter can be recognised as it is 

sealed inside a braiding. 
Once the container has been repositioned, make sure only the 
grease filter is visible. 

Replacing lamps 

Fig. 28 

The hood is equipped with a lighting system based on LED 
technology. 
The LEDs guarantee an optimum lighting, a duration up to 10 
times as long as the traditional lamps and allow to save 90% 
electrical energy. 
 
To purchase spare LEDs, contact the technical assistance 
service.