Electrolux LFU9216X - Инструкция по эксплуатации - Страница 4

www.electrolux.com

4

hood and filters will lead to the risk of fires.  The flaming of foods beneath the 

hood itself is severely prohibited. The use of exposed flames is detrimental 

to the filters and may cause a fire risk, and must therefore be avoided in all 

circumstances. 

Any frying must be done with care in order to make sure that the oil does not 

overheat and ignite.

 CAUTION: Accessible parts of the hood may become hot when used with 

cooking appliances.

For lamp replacement use only lamp type indicated in the Maintenance/

Replacing lamps section of this manual.

 WARNING! Do not connect the appliance to the mains until the installation 

is fully complete. 

When connecting the hood to the electrical network, only certified electrical 

adaptors are allowed and not power strips.

1.

SAFETY INSTRUCTIONS

With regards to the technical and safety 

measures to be adopted for fume discharging 

it is important to closely follow the regulations 

provided by the local authorities�

The ducting system for this appliance must 

not be connected to any existing ventilation 

system which is being used for any other 

purpose such as discharging exhaust fumes 

from appliances burning gas or other fuels� 

Do not use or leave the hood without the 

lamp correctly mounted due to the possible 

risk of electric shocks� Never use the hood 

without effectively mounted grids. The hood 

must NEVER be used as a support surface 

unless specifically indicated. Use only the 

fixing screws supplied with the product for 

installation or, if not supplied, purchase the 

correct screws type� Use the correct length 

for the screws which are identified in the 

Installation Guide� In case of doubt, consult 

an authorised service assistance centre or 

similar qualified person. 

 WARNING! 

Failure to install the screws 

or fixing device in accordance with 

these instructions may result in electrical 

hazards�

2.

USE

The hood serves to aspirate the fumes and 

vapors resulting from cooking�

The attached installation manual indicates 

the version to be used depending on the 

model you have, the suction version with 

external evacuation

or filtering with internal 

recirculation

�

In some models ONLY:

As optional accessory is supplied a Non 

return valve�

This should be installed inside the proper 

outlet hole housing in same cases only (i�e: 

in any case there's no protection against 

accidental backdraft air current from the 

outside)�

3.

INSTALLATION

The mains power supply must correspond 

to the rating indicated on the plate situated 

inside the hood� If provided with a plug 

connect the hood to a socket in compliance 

with current regulations and positioned in 

an accessible area, after installation� If it not 

fitted with a plug (direct mains connection) 

or if the plug is not located in an accessible 

area, after installation,  apply a double 

pole switch in accordance with standards 

which assures the complete disconnection 

of the mains under conditions relating to 

over-current category III in accordance with 

installation instructions�

Warning!

Before re-connecting the hood 

circuit to the mains supply and checking 

the efficient function, always check that 

the mains cable is correctly assembled�