DeLonghi KD-PR60X - Инструкция по эксплуатации - Страница 6

- 6 -

ENGLISH

GB

 GENERAL

Carefully read the following important information regarding 
installation safety and maintenance. Keep this information 
booklet accessible for further consultations. The appliance 
has been designed for use in the ducting version (air exhaust 
to the outside - Fig.1B), filtering version (air circulation on the 
inside - Fig.1A) or with external motor (Fig.1C).

  SAFETY PRECAUTION

1.

 Take care when the cooker hood is operating simultaneously 

with an open fireplace or burner that depend on the air in the 
environment and are supplied by other than electrical energy, 
as the cooker hood removes the air from the environment 
which a burner or fireplace need for combustion. The negative 
pressure in the environment must not exceed 4Pa (4x10-5 bar). 
Provide adequate ventilation in the environment for a safe 
operation of the cooker hood. Follow the local laws applicable 
for external air evacuation.

Before connecting the model to the electricity network:

- Control the data plate (positioned inside the appliance) 
to ascertain that the voltage and power correspond to the 
network and the socket is suitable. If in doubt ask a qualified 
electrician.
- If the power supply cable is damaged, it must be replaced with 
another cable or a special assembly, which may be obtained 
direct from the manufacturer or from the Technical Assistance 
Centre.
- This device must be connected to the supply network through 
either a plug fused 3A or hardwired to a 2 fase spur protected 
by 3A fuse.

2.  Warning!
In certain circumstances electrical appliances may be a 
danger hazard.
A)  Do not check the status of the filters while the cooker 
hood is operating.
B)  Do not touch bulbs or adjacent areas, during or straight 
after prolonged use of the lighting installation.
C)  Flambè cooking is prohibited underneath the cooker 
hood.
D)  Avoid free flame, as it is damaging for the filters and a 
fire hazard.
E)  Co n s t a nt l y   c h e c k   fo o d   f r y i n g   to   avo i d   t h at   t h e 
overheated oil may become a fire hazard.
F)  Disconnect the electrical plug prior to any maintenance.
G)  This appliance is not intended for use by young children 
or infirm persons without supervision.
H)   Young children should be supervised to ensure they do 
not play with the appliance.
I)   There shall be adequate ventilation of the room when 
the rangehood is used at the same time as appliances 
burning gas or other fuels.
L)  There is a risk of fire if cleaning is not carried out in 
accordance with the instructions.

This appliance conforms to the European Directive EC/2002/96, 
Waste Electrical and Electronic Equipment (WEEE). By making 
sure that this appliance is disposed of in a suitable manner, 
the user is helping to prevent potential damage to the 
environment or to public health.

The symbol on the product or on the accompanying 

paperwork indicates that the appliance should not be 
treated as domestic waste, but should be delivered to 

a suitable electric and electronic appliance recycling collection 
point. Follow local guidelines when disposing of waste. For 
more information on the treatment, re-use and recycling of 
this product, please contact your local authority, domestic 
waste collection service or the shop where the appliance was 
purchased.

  INSTALLATION INSTRUCTIONS

•  Assembly and electrical connections must be carried out 

by specialised personnel.

•  Wear  protective  gloves  before  proceeding  with  the 

installation.

•  Electric Connection:

Note! Verify the data label placed inside the appliance:
- If the symbol 

 appears on the plate, it means that no earth 

connection must be made on the appliance, therefore follow 
the instructions concerning insulation class II.
- If the symbol 

 DOES NOT appear on the plate, follow the 

instructions concerning insulation class I.

Insulation class II

- The appliance has been manufactured as a class II, therefore 
no earth cable is necessary. The plug must be easily accessible 
after the installation of the appliance. If the appliance 
is equipped with power cord without plug, a suitably 
dimensioned omnipolar switch with 3 mm minimum opening 
between contacts must be fitted between the appliance and 
the electricity supply in compliance with the load and current 
regulations.
- The connection to the mains is carried out as follows:
BROWN = 

L

 line

BLUE = 

N

 neutral.

Insulation class I

This is a class I, appliance and must therefore be connected to 
an effiecient earthing system.
- The appliance must be connected to the electricity supply as 
follows:
BROWN = 

L

 line

BLUE = 

N

 neutral

YELLOW/GREEN

= 

 earth.

The neutral wire must be connected to the terminal with the 

N 

symbol while the 

YELLOW/GREEN

, wire must be connected 

to the terminal by the earth symbol 

.

When connecting the appliance to the electricity supply, make 
sure that the mains socket has an earth connection. After fitting 
the ducted cooker hood, make sure that the electrical plug is 
in a position where it can be accessed easily. If the appliance 
is connected directly to the electricity supply, an omnipolar 
switch with a minimum contact opening of 3 mm must be 
placed in between the two; its size must be suitable for the 
load required and it must comply with current legislation.

•  

If the hob is electric, gas, or induction, the minimum distance 

between the same and the lower part of the hood must be at 
least 

65 cm

. If a connection tube composed of two parts is 

used, the upper part must be placed outside the lower part. Do 
not connect the cooker hood exhaust to the same conductor 
used to circulate hot air or for evacuating fumes from other 
appliances generated by other than an electrical source. Before 
proceeding with the assembly operations, remove the anti-
grease filter(s) (Fig.7A) so that the unit is easier to handle.