Candy CFT610 - Инструкция по эксплуатации - Страница 10

10 

WEEE subjected to specific treatments, in order to remove 
and dispose properly all pollutants, and recover and recycle all 
materials.  
Individuals can play an important role in ensuring that WEEE 
does not become an environmental issue; it is essential to 
follow some basic rules: 
 

−

WEEE should not be treated as household waste; 

−

WEEE should be handed over to the relevant collection 

points managed by the municipality or by registered 
companies. In many countries, for large WEEE, home 
collection could be present. 

 
In many countries, when you buy a new appliance, the old one 
may be returned to the retailer who has to collect it free of 
charge on a one-to-one basis, as long as the equipment is of 
equivalent type and has the same functions as the supplied 
equipment.  
 
Appliance designed, tested and manufactured according to: 
• Safety: EN/IEC 60335-1; EN/IEC 60335-2-31, EN/IEC 
62233. 
• Performance: EN/IEC 61591; ISO 5167-1; ISO 5167-3; ISO 
5168; EN/IEC 60704-1; EN/IEC 60704-2-13; ISO 3741; EN 
50564; IEC 62301. 
• EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-2; 
EN/IEC 61000-3-2; EN/IEC 61000-3-3. Suggestions for a 
correct use in order to reduce the environmental impact:  
Switch ON the hood at minimum speed when you start 
cooking and kept it running for few minutes after cooking is 
finished. Increase the speed only in case of large amount of 
smoke and vapour and use boost speed(s) only in extreme 
situations. Replace the charcoal filter(s) when necessary to 
maintain a good odour reduction efficiency. Clean the grease 
filter(s) when necessary to maintain a good grease filter 
efficiency. Use the maximum diameter of the ducting system 
indicated in this manual to optimize efficiency and minimize 
noise. 

By placing the 

  marking on this product, we declare, 

on our own responsability, compliance to all of European 
safety, health and environmental requirements stated in the 
legislation for this product. 

Installation 

The minimum distance between the supporting surface for the 
cooking equipment on the hob and the lowest part of the 
range hood must be not less than 50cm from electric cookers 
and 65cm from gas or mixed cookers. 
If the instructions for installation for the gas hob specify a 
greater distance, this must be adhered to. 
The template 

(*)

 can be used for installation. 

  Electrical connection 

The mains power supply must correspond to the rating 
indicated on the plate situated inside the hood. If provided with 
a plug connect the hood to a socket in compliance with current 

regulations and positioned in an accessible area, after 
installation. If it not fitted with a plug (direct mains connection) 
or if the plug is not located in an accessible area, after 
installation,  apply a double pole switch in accordance with 
standards which assures the complete disconnection of the 
mains under conditions relating to over-current category III, in 
accordance with installation instructions. 

Warning!

 Before re-connecting the hood circuit to the mains 

supply and checking the efficient function, always check that 
the mains cable is correctly assembled. 

Warning! 

If the supply cord is damaged, it must be replaced 

by the manufacturer, its service agent or similarly qualified 
persons in order to avoid hazard.  

Operation 

The hood is fitted with a control panel with aspiration speed 
selection control and a light switch to control cooking area 
lights. 

Maintenance 

Cleaning 

Clean using 

ONLY

 the cloth dampened with neutral liquid 

detergent. 

DO NOT CLEAN WITH TOOLS OR 

INSTRUMENTS

. Do not use abrasive products. 

DO NOT USE 

ALCOHOL! 
Grease filter - Carbon filter (*): 

it is/they are

mounted on the 

back of the grill and must be changed once a month.  
If the metal fats filter is envisaged in the model in your 
possession, this must be cleaned once a month with non-
aggressive detergent manually or in a dishwasher at low 
temperature and short cycle.   
The metal anti-fats filter might discolour by washing in a 
dishwasher but its filtering characteristics do not change at all.  

Replacing lamps 

Disconnect the appliance from the electricity. 

Warning! 

Prior to touching the light bulbs ensure they are 

cooled down. 
Replace the old light bulb with the one of the same type as 
specified in the feature label or near the light lamp on the 
hood. 
Replace the damaged lamp. 
Use Ø35mm E14 28W halogen candle lamps only. 
If the lights do not work, make sure that the lamps are fitted 
properly into their housings before you call for technical 
assistance.