Bosch DWP64CC60T - Инструкция по эксплуатации - Страница 6

en

    Cleaning and maintenance

6

2

Cleaning and maintenance

Cl eani ng and  mai ntenance

:

Warning – Risk of burns! 

The appliance becomes hot during operation. Allow the 

appliance to cool down before cleaning.

:

Warning – Risk of electric shock! 

Penetrating moisture may result in an electric shock. 

Clean the appliance using a damp cloth only. Before 

cleaning, pull out the mains plug or switch off the circuit 

breaker in the fuse box.

:

Warning – Risk of electric shock! 

Do not use any high-pressure cleaners or steam 

cleaners, which can result in an electric shock.

Cleaning agents

To ensure that the different surfaces are not damaged 

by using the wrong cleaning agent, observe the 

information in the table. Do not use any of the following:

■

Harsh or abrasive cleaning agents,

■

Cleaning agents with a high alcohol content,

■

Hard scouring pads or cleaning sponges,

■

High-pressure cleaners or steam cleaners.

Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the 

cleaning agents.

Removing and installing the filter

The filter must be serviced regularly in order to 

guarantee efficient filtration of odours and grease.

Metal grease filter

The metal grease filters must be cleaned every 

100 operating hours or at least every two months.

:

Warning – Risk of fire! 

Grease deposits in the grease filter may catch fire.

Clean the grease filter at least every 2 months. 

Never operate the appliance without the grease filter.

Activated charcoal filter (only in circulating-air mode)

To ensure effective odour removal, the filters must be 

serviced regularly.
The activated charcoal filters must be replaced at least 

every 3 months.

Notes

■

The activated charcoal filters are not included with 

the appliance. Activated charcoal filters are available 

from specialist retailers, from our after-sales service 

or from our online shop.

■

The activated charcoal filters cannot be cleaned or 

reactivated.

Removing metal grease filter

The metal grease filters filter the grease out of kitchen 

steam. To keep them in good working order, the filters 

should be cleaned at least every two months.

1.

Open the lock on the metal grease filters and 

remove the filters from the retainer. 

Notes

– When you do this, take hold of the metal grease 

filters from underneath with your other hand.Make 

sure that the metal grease filters do not fall and 

damage the hob.

– Fat may accumulate in the bottom of the metal 

grease filters. Hold the filters level to prevent fat 

from dripping out.

2.

Clean the metal grease filters.

3.

Clean the inside of the appliance.

Area

Cleaning agent

Stainless steel

Hot soapy water: 

Clean with a dish cloth and then dry with a 

soft cloth.
Clean stainless steel surfaces in the grind 

direction only.
Special stainless steel cleaning products are 

available from our after-sales service or from 

specialist retailers. Apply a very thin layer of 

the cleaning product with a soft cloth.

Painted surfaces

Hot soapy water: 

Clean using a damp dish cloth and dry with a 

soft cloth/towel.
Do not use any stainless steel cleaners.

Aluminium and plastic Glass cleaner: 

Clean with a soft cloth.

Glass

Glass cleaner: 

Clean with a soft cloth. Do not use a glass 

scraper.

Controls

Hot soapy water: 

Clean using a damp dish cloth and dry with a 

soft cloth/towel.
Risk of electric shock caused by penetrating 

moisture.
Risk of damage to the electronics from pene-

trating moisture. Never clean operating con-

trols with a wet cloth.
Do not use any stainless steel cleaners.