AEG DCE3960HM - Инструкция по эксплуатации - Страница 6

6

www.aeg.com

4. CONTROLS

Button Function

Led

L

Turns the lights on/off at maximum strength.

-

T1

Turns the motor on/off at speed one.

Fixed.

T2

Turns the Motor on at speed two.

Fixed.

Press and hold the button for approximately 3 seconds, with 

all the loads turned off (Motor and Lights), to turn the Activated 

Charcoal Filter alarm on. The relevant LED flashes twice to confirm.

To turn the alarm off, press the button again and hold for at least 

3  seconds.  The  relevant  LED  flashes  once.

-

T3

Turns the Motor on at speed three.

Fixed.

Press and hold the button for approximately 3 seconds, with all 

the loads turned off (Motor and Lights), to perform a reset. The 

LED  S1  flashes  three  times.

-

T4

Turns the Motor on at INTENSIVE Speed.

Fixed.

This speed is timed to run for 6 minutes. At the end of this time, 

the system returns automatically to the speed that was set before. 

If it is activated with the motor turned off, the hood will switch to 

OFF at the end of the time.

Press and hold for 3 seconds to enable the remote control, 

indicated  by  the  LED  flashing  twice.

Press and hold for 3 seconds to disable the remote control, 

indicated  by  the  LED  flashing  just  once.

-

S1

Signals the Metal Grease Filter saturation alarm, indicating that it 

is  necessary  to  wash  the  filters.  The  alarm  is  triggered  after  the 

Hood has been in operation for 100 working hours.

Fixed.

When this is activated, it signals the Activated Charcoal Filter 

saturation  alarm,  indicating  that  the  filter  must  be  changed;  the 

Metal Grease Filters must also be washed. The Activated Charcoal 

Filter saturation alarm comes into operation after the Hood has 

been working for 200 hours.

Flashing.