Timberk WHE 5.5 XTR H1 - Инструкция по эксплуатации - Страница 15

15

www.timberk.com

electric instant water heater

Water Heater Operation

1.   During the first water heater start-up or after long-term non-use, fill 

the device with water by opening the cut-off tap at cold water 
supply line, and make sure that there is a steady cold water flow at 
water outlet at the consumption point, after that switch on the 
device power supply, indicating lamp 1 at the control panel (see 
Fig.15) starts blinking.

2.   To switch on the device, press «      » button at the control panel, 

power supply indicator 1 (see Fig.15) will be constantly lit up.

3.   Water temperature can be set within +35°  to +60°  range with the 

help of «      » button (value increase) and «      » (value decrease).  If 
water heater does not heat up to the temperature set, water flow 
shall be reduced with the help of the tap at the inlet nozzle.

4.   Water flow is controlled by the tap at water inlet to or outlet from 

water heater. When there is water flow, and water pressure is not 
less than 0.1 MPa, heating is switched on automatically, and 
indicating lamp 2 located at the control panel lights up (see Fig.15). 

5.   After

heating

is

switched

on

, 

you

need

to

wait

for

 10-20 

seconds

to

let

temperature

of

heated

water

stabilize

.

6.   Incoming water is heated up inside the heating flask when it is 

flowing through the heating element. Water temperature in the 
water supply main may vary depending on a season from +3°  to 
+20° , so, in winter water flow shall be less than in summer to 
assure the optimum water temperature.

       To switch off the water heater, simply close water flow at the inlet 

to or outlet from the device; electronic flow sensor automatically 
opens the circuit of power supply to heating element, and 
indicating lamp 2 located at the control panel goes down (see 
Fig.15), and power supply indicator 1 starts blinking. For the 
subsequent switching on of heating it is enough to reopen the 
water supplying or water draining tap.

7.   Temperature switch stops the power supply to heating element in 

the event of water overheating inside water heater. If water heater 
is connected to the electric main, and water heating is switched on, 

ATTENTION

!

Do not switch on the water heater if there are grounds to suspect 

that water inside it has frozen.

but water is not heated up, it means that the temperature switch 
has tripped out or was not enabled. To return the water heater to 
operating mode, the button at temperature switch shall be pressed. 
Proceed as follows:

      - Switch off the power supply to water heater, remove the front 

panel, press the black button located in the central part of 
temperature switch till it clicks; the temperature switch is located at 
water heater flask.

ENGLISH

ATTENTION

!

If these activities have not resulted in any positive outcome or tem-

perature switch trips out repeatedly within a short period of time, 

switch off power supply to water heater, close water supply to water 

heater and address the Authorized Timberk Service Center located 

at your region to receive any advice or maintenance. For the address 

of the Authorized Service Center, please, consult with the seller or 

visit our web-site at 

.

www.timberk.com