Timberk SWH FEL1 50 V - Инструкция по эксплуатации - Страница 9

www.timberk.com • electrical storage water heater

9

IMPORTANT! 

To provide reliable operation and safe use of the 

water heater, prior to the first run check if it is properly 

connected to the 220~/50 V AC mains. The water 

heater to be connected must be securely linked with 

the earth circuit of your electric mains. 

IMPORTANT! 

Wall outlet should be rated on voltage not lower than 

10А, electric main cabel with cooper section not 

lesser then 3х1,5 mm

2

 (for cooper).

Electric socket should be no lower, than 10A, power card with copper inner 

part, cross-section of copper should be not less, than 3x1,5 mm

2

. 

8. WATER HEATER CONTROL

Control panel

1. Thermostat handle
2. Power supply Indicator 
3. Heating indicator
4. LED - display

Fig. 7

Water heater operation

1. Switching on

1.1 At first, open one of the hot water outlet valves, then open the cold 

water supply valve. The electric water heater will start filling with water. 

When water flows from the hot tap freely, it means the water heater is fully 

filled with water and you can close the hot water outlet valve.

NOTE:

When setting temperature, having reached the 

optimal heating position “        ” (+58°С (+/- 2°С), you 

will hear a sound signal (for some models).

1.2 Plug the power cord into the outlet, at that an indicator light on control 

panel. 

2. Water heating temperature setting

2.1. Temperature can be set within the range 35°С-75°С, in increments 

of 1°С.

2.2 The water heater automatically maintains water temperature. When 

water temperature in the water heater reaches the temperature, set by the 

NOTE:

During normal operation the cold water supply valve 

must be set “open”.

user, the heating is automatically switched off.  When water temperature 

in the water heater drops to a certain level, the heating is automatically 

switched off.

IMPORTANT! 

Water may start dripping from the relief valve hole 

during heating. It is impossible to avoid water leakage 

and you must not prevent it since valve blocking 

may cause rupture of the internal tank (in case of 

equipment failure).

2

3

4

1

54