Clage CDX 11-U 057604 - Инструкция по эксплуатации - Страница 8

8

CDX 7-U / CDX 11-U BASITRONIC

®

Problem

Cause

Solution

Water stays cold

Master fuse tripped

Renew or aktivate fuse

Safety pressure cut-out 
tripped 

Contact customer service

Safety thermal cut-out 
tripped 

Contact customer service

Flow rate of hot water too 
weak

Outlet fitting dirty or 
calcified

Clean shower head, jet regu-
lator or sieves 

Fine filter dirty or cal-
cified

Let clean fine filter by a spe-
cialist

Selected temperature is 
not reached 

Excessive water flow 
(winter?)

Reduce water flow rate at 
the outlet 

Water perceived to be too 
cold

Set temperature too low

Increase set temperature by 
a specialist

Water perceived to be too 
hot

Set temperature too 
high

Decrease set temperature by 
a specialist 

4. Trouble­shooting and service

This instantaneous water heater was manufactured conscientiously and checked sever-
al times before delivery. Should malfunctions nevertheless occur, it is usually only due 
to a bagatelle. First attempt to switch the house fuses off and on again in order to reset 
the electronics. Next, try to remedy the problem with reference to the following table. 
In doing so, you will avoid unnecessary expense of customer service assistance.

Repairs must only be carried out by 
authorised professionals.
If a fault in your appliance cannot be 
rectified with the aid of this table, 
please contact the service organisa­
tion of your importer or the Central 
Customer Service Department. Please 
have the details of the typeplate at 
hand.

CLAGE GmbH
Customer Service

Pirolweg  1 – 5 
21337 Lüneburg 
Germany

Tel: 

+49 4131 8901-40 

Fax:  +49 4131 8901-41 
Email: service@clage.de

If the connection cable is damaged, it must be replaced with an original spare cable 
from the manufacturer by an authorised technician in order to avoid any hazards.
If you cannot rectify the fault with the aid of the troubleshooting table, please contact 
the custo mer service.