Atlantic 200 VS 882138 - Инструкция по эксплуатации - Страница 10

EN

8

Installation manual

If steam or boiling water emerges continuously from the drain plug or drain tap, switch off the electricity and call a professional.
When first powered, a smoke and an odor may be released from the heating element. This is normal and it disappears after a few minutes.

MAINTENANCE

User maintenance: 

Operates once a month the discharge of water security to prevent scaling and verify that it is not blocked. If this is not done, damage may be caused and 
the guarantee invalidated.

Maintenance by a qualified person:

a) Remove the scale sludge. Do not scrape or chip at lime scale deposited on the casing because this may damage the lining
b) Change the magnesium anode every 2 years or when its diameter is less than 10 mm. Changing the shielded heating element or the anode requires the 
water heater to be drained and the seal changed.

Drain: 

Turn off the power and the supply of cold water, open the hot water faucets and manipulate the safety valve before performing these operations. Refit 
the heating element and tighten the screws gently (opposite screws in sequence), check for leaks the next day and tighten if required.
If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent.

Replaceable parts: 

The thermostat, seals, heating element, boiler shell, the indicator light, the magnesium anode, the connection cable. The guarantee requires genuine 
manufacturer’s parts to be used.

Do not dispose your water heater in the garbage, but hand it to a place assigned for this purpose (collection point) where it can be recycled.

SCOPE OF THE GUARANTEE

The water heater must be installed, used and maintained according to best practice and conform to the standards in force in the country in which  
it is installed and to the instructions contained in this document.
In the European Union this appliance is covered by the statutory guarantee accorded to consumers in accordance with directive 1999/44/CE. This guarantee 
comes into force when the appliance is delivered to the consumer. In addition to the legal guarantee, certain items are covered by an extra guarantee 
relating only to the free exchange of the tank and of components accepted as defective. It does not include the cost of replacement or carriage. Refer 
to the table below.
This commercial guarantee does not affect your statutory rights. It applies within the country where the product was acquired, provided it is also installed  
in the same country. The dealer must be informed of any damage before the product is exchanged under guarantee and the appliance will remain  
available for inspection by experts from the insurance company and the manufacturer.

The duration of commercial 

guarantee

Range

IMMERSION ELEMENT

STEATITE

ACI

Statutory

2 years all parts

2 years all parts

2 years all parts

Extra commercial guarantee on 
tanks and heating elements, except 
for electrical components

+ 3 years 

(for Ireland : + 0 year)

+ 3 years 

(for Ireland : + 0 year)

+ 3 years 

(for Ireland : + 0 year)

The change of a component does not extend the warranty period of the device. To claim under guarantee, contact your installer or dealer. If necessary, 
contact  :  ATL  INTERNATIONAL  Tel.:(33)146836000,  Fax  (33)146836001  -  58  av  Gén.  Leclerc  92340  Bourg-la-Reine  (France)  who  will  inform  you  of  what  
you should do. The guarantee applies only to examined products which are accepted as faulty by the company underwriting the guarantee. It is essential 
that products should be retained for inspection by them.

Exclusions: Wear parts : magnesium anodes…. ; equipment which cannot be assessed (access difficult for repair, maintenance or assessment) ; equipment 
exposed  to  abnormal  environmental  conditions  :  frost,  bad  weather,  water  which  is  abnormally  aggressive  or  outside  drinking  standards,  electrical  
supply  with  large  spikes  ;  equipment  installed  without  observing  current  standards  in  the  country  of  installation  :  the  absence  or  incorrect  fitting  
of safety devices, abnormal corrosion due to incorrect water fitments (iron/copper contact), incorrect earthing, inadequate cable thickness, non observance  
of the connection drawings shown in these instructions ; equipment not maintained in accordance with these instructions ; repairs or replacement of parts 
or components in the equipment not carried out or authorised by the company responsible for the guarantee. 

These devices comply with the directive 2014/30/UE according to electromagnetic compatibility, 2014/35/UE according to low voltage, 2011/65/UE accor-
ding to ROHS directive and Commission Delegated Regulation 2013/814/UE supplementing 2009/125/EC regulation for ecodesign.