Ariston ABS VLS EVO QH 100 D - Инструкция по эксплуатации - Страница 17

Electromechanical  water  heaters  are  sold  with  the  thermal  sanitisation  cycle  disabled  (default  setting). 
If,  for  some  reason,  any  of  the  above ‘’Conditions  in  favour  of  the  proliferation  of  Legionella’’  occurs,  it 
is  strongly  recommended  to  enable  this  function  according  to  the  instructions  found  in  this  manual  [see 
<<

Activating  the ‘’thermal  disinfection  cycle’’  (anti-legionella)

>>].  However,  the  thermal  disinfection 

cycle does not kill all Legionella bacteria in the storage tank. It follows that if the function is disabled, the 
Legionella bacteria may reoccur. 
Note: when the software performs the thermal sanitisation treatment, it is likely that the power consumption 
of the water heaters increases.

Caution:

  the water temperature in the tank can cause immediate serious burns when the software runs 

the thermal disinfection treatment. Children, disabled persons and the aged are particularly at 
risk of burns. Check the water temperature before taking a bath or shower.

TECHNICAL CHARACTERISTICS 

outlet pipes).  

This appliance is conforming with the international electrical safety standards IEC 60335-1 and IEC 

60335-2-21. 
The products are compliant according to: 
- TP TC 004/2011 “Technical regulations of the Customs Union on safety of low voltage equipment”
- TP TC 020/2011 “Technical regulations of the Customs Union on electro-magnetic compatibility”.

Table 3 - Product information

Range  

30

50

80

100

Weight (kg)

16

21

27

32

CAUTION Observe all general warnings and safety standards listed at the begin-

ning of this text in full; all such instructions are obligatory.  

INSTALLING NORMS (for the installer)  

established regulations and local health and safety regulations. 

The appliance heats water to a temperature below boiling point. It must be linked up to a mains water sup-

necessary to: 

- 

Check whether the characteristics (please refer to the data plate) meet the customer’s requirements. 

- 

Make sure the installation conforms to the IP degree (of protection against the penetration of liquids) of 

the appliance according to the applicable norms in force. 
- Read the instructions provided on the packaging label and on the appliance data plate.  

Installing the appliance 

This appliance was designed to be installed only inside buildings in compliance with the applicable norms 

in force. 
Furthermore, installers are requested to keep to the following advice in the presence of: 
- 

Damp

: do not install the appliance in closed (unventilated) and damp rooms. 

- 

Frost

: do not install the appliance in areas where the temperature may drop critically and there may be a 

risk that ice may form. 

- 

Sunlight

: do not expose the appliance to direct sunrays, even in the presence of windows. 

- 

Dust/vapours/gas

: do not install the appliance in the presence of particularly dangerous substances such 

as acidic vapours, dust or those saturated with gas. 

-

  Electrical  discharges

:  do  not  install  the  appliance  directly  on  electrical  supplies  that  aren’t  protected 

against sudden voltage jumps.

EN

RU

40

17