Ariston ABS ANDRIS2 R 15 O - Инструкция по эксплуатации - Страница 9

EN

9

GENERAL SAFETY INSTRUCTIONS

1.  

Read the instructions and warning in this manual carefully, 

they contain important information regarding safe installa-

tion, use and maintenance. 

This manual is an integral part of the product. Hand it on to 

the next user/owner in case of change of property.

2.   The manufacturer shall not liable for any injury to people, ani-

mals or damage to property caused by improper, incorrect or 

unreasonable use or failure to follow the instructions reported 

in this publication.

3.  Installation and maintenance must be performed by profes-

sionally qualified personnel as specified in the relative para-

graphs. Only use original spare parts.

Failure to observe the 

above instructions can compromise the safety of the appliance 

and 

relieves

 the manufacturer of any liability for the conse-

quences.

4.   DO NOT leave the packaging materials (staples, plastic bags, 

expanded polystyrene, etc.) within the reach of children - they 

can cause serious injury.

5.   The appliance may not be used by persons under 8 years of 

age, with reduced physical, sensory or mental capacity, or 

lacking the requisite experience and familiarity, unless under 

supervision or following instruction in the safe use of the appli-

ance and the hazards attendant on such use. DO NOT permit 

children to play with the appliance. User cleaning and mainte-

nance may not be done by unsupervised children.

6.  

DO NOT

 touch the appliance when barefoot or if any part of 

your body is wet.

7.  Before using the device and after routine or extraordinary main-

tenance, we recommend filling the appliance's tank with water 

and draining it completely to remove any residual impurities.

8.  If the appliance is equipped with a power cord, the latter may 

only be replaced by an authorised service centre or professional 

technician.

9.   It is mandatory to screw on the water inlet pipe of the unit a 

safety valve in accordance with national regulations. In coun-

tries which have enacted EN 1487, the safety group must be 

calibrated to a maximum pressure of 1487 MPa (0,7 bar) and 

include at least a cock, check valve and control, safety valve 

and hydraulic load cutout.