AEG MP 8 220395 - Инструкция по эксплуатации - Страница 15

19

For the Professional

English

3.3

Elimination of faults

Cause

The water flow rate required for the
system to switch on has not been
achieved (see Table 2).
– Dirt contamination or limescale

formation in the flow regulator in
the fitting or in the shower head.

The water flow rate required for the
system to switch on has not been
achieved (see Table 2).
– The screen in the cold-water supply

line is blocked.

– Flow rate too small.

– The safety thermal cut-out has

switched the unit off for safety
reasons.

– Heating element clogged with

limescale (caused by heat thermal
cut-out build-up).

– Heating element defective.

Rectification

– Cleaning or descaling of the flow

regulator in the fitting or in the
shower head.

– Clean the filter (Fig. 11, Item 1)

after shutting off the cold water
cable entry.

– Correct the flow rate.

– Eliminate the cause of the fault.

Press the reset button on the safety
thermal cut-out (Fig. 10, Item 1).
The current to the unit must be
disconnected.

– Replace heating element

Fault

No hot water despite the hot water
fitting being fully opened.

The flow-rate sensor does not switch
on the heater even though the hot-
water tap is fully open.

The appliance does not heat the
water.

Elimination of faults by the user

Elimination of faults by the qualified installer

4.

Guarantee

For guarantee please refer to the respective terms and conditions of supply for your country.

The installation, electrical connection and first operation of this appliance should be carried out
by a qualified installer.

The company does not accept liability for failure of any goods supplied which are not installed in
accordance with the manufacturer's instructions.

4.1

Environment and recycling

Please help us to protect the environment by disposing of the packaging in accordance with the
national regulations for waste processing.