Liebherr WKUes 1753 - Инструкция по эксплуатации - Страница 4

16

Setting up

• Avoid locating the appliance it in direct sunlight or near heat sources such as an oven 

or a radiator.

• The floor should be level and even.  You can compensate for an uneven floor by ad-

justing the adjustable feet. 

• Standard EN 378 specifies that the room in which you install your appliance must 

have a volume of 1 m

3

 per 8 g of R 600a refrigerant used in the appliance, so as to 

avoid the formation of inflammable gas/air mixtures in the room where the appliance 
is located in the event of a leak in the refrigerant circuit.  The quantity of refrigerant 
used in your appliance is indicated on the type plate on the inside of the appliance.

• The appliance is set to operate within specific ambient temperature limits according 

to its climate rating. These temperature limits should not be exceeded. The correct 
climate rating for your appliance is indicated on the type plate. 

  SN = +10°C to +32°C
  SN - ST = +10°C to +38°C

Electrical requirement

Power supply (AC) and voltage at the operating point must comply with the details on 
the type plate. The type plate is located on the top left-hand side on the inside of the 
appliance. The socket must be fused with a 10 A fuse or higher, it must be away from 
the rear of the appliance and must be easily accessible.

Fitting dimensions (mm)

•  Adjust to recess height using the 4 

adjustable feet on the underside of the 
appliance.

• Connect the appliance to the mains.
•  Slide the appliance into the recess.
•  Secure the appliance in the recess us-

ing 4 x 14 screws.

Installation and fitting

The ventilation cross-section in the plinth panel must be min. 300 cm².