Винные шкафы Liebherr WKEes 553 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.

11
Audible warning signal
The audible warning signal helps to protect your wines against
excessive temperatures.
It sounds when the door has
been left open for longer than
60 seconds.
It sounds when the interior gets
too warm or too cold. The tem-
perature display will also flash.
The symbol lights up.
The audible warning device is switched off by pressing the
Alarm
button.
The temperature display will continue to flash until the cause of
the alarm has been rectified.
Interior light
The interior light is fitted on the
inside at the top.
The interior light can be switched
on and off using the
Light
but-
ton.
The symbol lights up when the
light is switched on.
Caution - class 1M laser radiation. When cover is removed,
do not look directly at light through optical instruments.
The lighting may only be replaced by the customer service
technician or by competent skilled personnel!
Furthermore, the brightness of the lighting can be adjusted.
Press and hold the
Light
button and at the same time press the
temperature setting buttons to increase or decrease the bright-
ness.
Down
= darker ,
Up
= brighter
GB
Setup mode
The following functions can be activated in setup mode:
= child lock, = display brightness
=
Child lock
The child lock is designed to protect the appliance from being
switched off accidentally.
Activating the child lock
• Activate setup mode by pressing the
button for 5 sec-
onds.
- The display reads .
• Press the
button.
- The display reads .
• Press the
button again.
- The
symbol will light up to indicate that the child lock is acti-
vated.
• Exit setup mode by pressing the button.
Deactivating the child lock
• Activate setup mode by pressing the
button for 5 sec-
onds.
- The display reads .
• Press the
button.
- The display reads .
• Press the
button again.
- The
symbol will go out, indicating that the child lock is deac-
tivated.
• Exit setup mode by pressing the button.
=
Display brightness
Adjusting the display brightness
• Activate setup mode by pressing the
button for 5 sec-
onds.
• Press the
button until appears in the display.
Press the
button.
- The display reads
5
.
• Press the
buttons and set the brightness between
0
= minimum and
5
= maximum.
• When you reach the desired level, press the
button.
• Exit setup mode by pressing the
button.
• Close the door. The new setting will activate after about
1 minute.
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)