Fhiaba S5990FW3 - Инструкция по эксплуатации - Страница 20

46

11

11.1

11.2

11.3

www.fhiaba.com ∙ info@fhiaba.com ∙ Tel +39 (0)434 420160 ∙ Fax +39 (0)434 420161

Care and Cleaning

Care and Cleaning

Condenser cleaning

Internal cleaning

Scrupulously follow the detailed directions that can be found 

in the provided kit and never use abrasive or metallic products 

which could scratch and damage the satin finishing on the ap

-

pliance permanently.

Before performing any sort of cleaning, disconnect the appliance 

from the electrical power supply.

Make sure you do not damage the refrigerant circuit in any 

way.

Do not bring cold glass parts into contact with boiling water. 

Do not wash any parts of the refrigerator in a dishwashing 

machine since this could damage or irreparably deform the 

parts.

Clean the internal and removable parts by washing them 
with a solution of lukewarm water, a small amount of dish-
washing detergent.

Rinse and dry right away.

Do not use mechanical devices or other methods to speed up 
defrosting.

The edges of the condenser are sharp, therefore use adequate 

protection for the hands and arms when cleaning the con-

denser.

Do not use water on the electrical parts, lights and control 

panel. 

To clean the parts made of steel use a microfiber cloth and 

the sponge provided in the kit with the appliance. Always 

use the cloth and sponge in the direction of the steel’s satin 

finish.

Every now and then, to polish the steel, wipe with a slightly 

damp microfiber cloth.

Do not use the sponge on aluminium parts, such as the han-

dles and the profiles of the glass shelves. 

You should use special care to keep the ventilation open-

ings in the appliance or in the cabinet that houses it free of 

obstructions.

A ventilation grille is located either at the top of the appli-

ance or at the bottom according to the model type. 

To clean it use a vacuum cleaner with a soft brush attach-

ment at maximum power, sweeping it along the vent slits. In 

case of a significant dust build up, the ventilation grille can 

be removed to allow a more accurate cleaning of the filter.

Ever y  6  months  the  display  shows  the  message  “Check 

Cond”, clean the condenser and press for 5 seconds the En-
ter 

button to reset.

Operate as follows:

  Switch off the appliance by pressing the Unit button   on 

the main control panel for approx 3 seconds.

  Wait  approx  30  minutes,  until  the  finned  condenser  cools 

down to room temperature.

  On models with ventilation at the base remove the grille 

at the bottom (magnetically attached) and take it off. On 

models with ventilation lift the grille as shown in the picture.

  Thoroughly clean the grille and the foam filter, by means of 

a vacuum cleaner and the soft brush attachment.

  Clean it thoroughly from any dust build up as shown in the 

picture, taking care not to damage it.

  Start up the appliance again, by pressing the Unit button 

 on the main