Sony DCR-TRV820E - Инструкция по эксплуатации - Страница 172

172

W h e n  o p e r a t i n g  u si n g  t h e  p r i n t e r

– D CR-TRV 8 2 0 E o n l y

Sympt om

Cause and/ or Correct ive Act ions

• The print cartridge is not inserted.

c

Insert the print cartridge. (p. 146)

• The printer cover is closed.

c

Slide the printer cover to open. (p. 149)

• You have inserted print paper into the paper feeder right after

you turn the power source on.

c

Remove the print paper once. Make sure that the PRINT
PAPER lamp is flashing slowly, and then insert print paper
into the paper feeder. (p. 149)

• The POWER switch is not set to VTR or MEMORY.

c

Set it to VTR or MEMORY. (p. 149)

• The print paper is not inserted properly.

c

Press the print paper into the paper feeder for about two
seconds after the beep sounds. (p. 149)

• The tape is running.

c

Press 

x

 STOP button. (p. 36)

• Printing images continuously makes the inside of the printer

heat up. When this happens, you may not be able to insert print
paper.

c

Leave your camcorder until it cools down, then insert print
paper into the paper feeder again.

• If you disconnect the power source such as the battery pack

during printing, the platen roller may not move back to the
original position.

c

Install the charged battery pack, and perform the operation
again. (p. 149)

• Print paper or the print cartridge is not inserted.

c

Insert the print paper or the print cartridge. (p. 146, 149)

• You have pressed PRINT lightly.

c

Press PRINT deeper. (p. 156)

• Print paper is inserted.

c

Remove the print paper. (p. 150)

• Printing is executed.

c

Remove the print cartridge after the printing is completed.
(p. 148)

• Removal switch is not slid to the end.

c

Slide it to the end.

• The ribbon is jammed in the cartridge compartment.

c

Contact your Sony dealer or local authorized Sony service
facility.

• If you disconnect the power source such as the battery pack

during printing, the platen roller may not move back to the
original position.

c

Install the charged battery pack, set the POWER switch to
VTR or MEMORY and open the LCD panel and the printer
cover.

• If you disconnect the power source such as the battery pack

during printing, the platen roller may not move back to the
original position.

c

Install the charged battery pack, set the POWER switch to
VTR or MEMORY and open the LCD panel and the printer
cover.

Print paper cannot be drawn in the
paper feeder.

When you print images recorded on
the “Memory Stick,” printing does
not start even you press PRINT.

Images do not become still images
even you press PRINT.

The print cartridge cannot be
removed from the cartridge
compartment.

Tr o u b l e sh o o t i n g

You cannot insert the print cartridge.