Ryobi R18 - Инструкция по эксплуатации - Страница 16

or tape. Do not transport batteries that are cracked or 
leaking. Check with the forwarding company for further 
advice.

KNOW YOUR PRODUCT

See page 78.

1. Adjustable head
2. Switch
3.  Low speed (I)
4. Off (O)
5.  High speed (II)
6. Battery port
7. J hook
8. Mounting holes

MAINTENANCE

 WARNING

The product should never be connected to a power supply 
when you are assembling parts, making adjustments, 
cleaning, performing maintenance, or when the product 
is not in use. Disconnecting the product will prevent 
accidental starting that could cause serious injury.

■

When servicing, use only original manufacturer’s 

replacement parts. Use of any other parts may create a 
hazard or cause product damage.

 WARNING

For greater safety and reliability, all repairs should be 
performed by an authorised Ryobi service centre.

GENERAL

Avoid using solvents when cleaning plastic parts. Most 
plastics are susceptible to various types of commercial 
solvents and may be damaged by their use. Use clean 
cloths to remove dirt, carbon dust, etc.

 WARNING

Do not, at any time, let brake 

fl

 uids, gasoline, petroleum-

based products, and penetrating oils, come in contact 
with plastic parts. They contain chemicals that can 
damage, weaken, or destroy plastic.

The dust from plaster and wall board is abrasive and 
may cause premature failure of the product if it is allowed 
to enter the motor area. Always use the dust extraction 
accessory connected to a vacuum. Do not use the product 
as an extraction system for dust. Thoroughly clean the 
product after use by using a brush and a vacuum. Take 
care not to push dirt into the ventilation openings. Do not 
use compressed air to clean the product because dust  and 
grit can cause serious eye injury.

LUBRICATION

All of the bearings in the product are lubricated with a 
suf

fi

 cient amount of high grade lubricant for the life span of 

the product under normal operating conditions. Therefore, 
no further lubrication is required.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing 
of as waste. The machine, accessories and 
packaging should be sorted for environment-
friendly recycling.

SYMBOLS ON THE PRODUCT

Safety alert

CE conformity

No-load speed

EurAsian Conformity Mark

Ukrainian mark of conformity

Please read the instructions carefully before 
starting the machine.

Waste electrical products should not be 
disposed of with household waste. Please 
recycle where facilities exist. Check with your 
local authority or retailer for recycling advice.

SYMBOLS IN THIS MANUAL

Parts or accessories sold separately

Low speed

High speed

Disconnect the battery pack

The following signal words and meanings are intended to 
explain the levels of risk associated with this product:

English

2