Zanussi ZGL 66 ITX - Инструкция по эксплуатации - Страница 5

5

O n c e   t h e   h o b   h a s   b e e n   i n s t a l l e d ,   i t   i s
important to remove any protective materials,
which were put on in the factory.

Hob burners control knobs

The hob burners control knobs are situated on the hob
right hand side. The symbols on the knobs mean that:

there is no gas supply

there is maximum gas supply

there is minimum gas supply

Lighting the burners

For easier lighting,  proceed before putting a
pan on the pan support.

To light a burner, push in the relevant knob and
turn it anticlockwise to "maximum position".
After lighting the flame, keep the knob pushed
down for about 5 seconds. This will allow the
"thermocouple" (Fig. 1, lett. D) to be heated and
the safety device to be switched off, otherwise the
gas supply would be interrupted.
Then, check the flame is regular and adjust it as
required.
If you cannot light the flame even after several
attempts, check the "cap" (Fig. 1, lett. A) and the
"crown" (Fig. 1, lett. B) are in the correct position.
To put the flame out, turn the knob to the symbol        .

•

Always turn the flame down or put it out before
taking the pans off the burner.

Do not keep the control knob pressed for more

than  15 seconds.

If the burner does not light even after 15 seconds,
release the control knob,  turn it the “off” position
and wait for at least one minute before trying to
light the burner again.
If the burner accidentally goes out, turn the control
knob to the “off” position and wait for at least 1
minute before trying to light the burner again.

Instruction for the User

Fig. 1

A

- Burner cap

B

- Burner crown

C

- Ignition candle

D

- Thermocouple

"

"

"

"

"

•

    •