Zanussi ZGG 62411 XA - Инструкция по эксплуатации - Страница 6

A

B

C

A) Burner cap

B) Burner crown

C) Ignition candle

Warning!

 Do not keep the control knob

pushed for more than 15 seconds.

If the burner does not light after 15 seconds,
release the control knob, turn it into off position

and try to light the burner again after minimum
1 minute.

Important!

 In the absence of electricity you

can ignite the burner without electrical device;
in this case approach the burner with a flame,
push the relevant knob down and turn it
counter-clockwise to maximum gas release
position.

If the burner accidentally goes out, turn the
control knob to the off position and try to

light the burner again after minimum 1 minute.

The spark generator can start automatical-
ly when you switch on the mains, after in-

stallation or a power cut. It is normal.

Turning the burner off

To put the flame out, turn the knob to the sym-

bol 

 .

Warning!

 Always turn the flame down or

switch it off before you remove the pans

from the burner.

Helpful hints and tips

Warning!

 Refer to the Safety chapters.

Energy savings

• If possible, always put the lids on the pans.

• When the liquid starts to boil, turn down the

flame to barely simmer the liquid.

Use cookware with diameters applicable to the
size of burners.

Burner

Diameters of cookware

Rapid

160 - 260 mm

Semi-rapid

120 - 220 mm

Auxiliary

80 - 160 mm

Warning!

 Make sure that the bottoms of

pots do not stand above the control

knobs. If the control knobs are under the
bottoms of pots, the flame heats them up.
Do not put the same pan on two burners.

Warning!

 Make sure that pot handles is

not above the front edge of the cooktop.

Make sure that pots are centrally put on the
rings in order to get maximum stability and to
get lower gas consumption.

Do not put unstable or damaged pots on the
rings to prevent from spill and injury.

Warning!

 Do not use a flame diffuser.

6

www.zanussi.com