Zanussi ZGG 62411 XA - Инструкция по эксплуатации - Страница 3

• Unattended cooking on a hob with fat or oil can be dangerous

and may result in fire.

• Never try to extinguish a fire with water, but switch off the appli-

ance and then cover flame e.g. with a lid or a fire blanket.

• Do not store items on the cooking surfaces.
• Do not use a steam cleaner to clean the appliance.
• Metallic objects such as knives, forks, spoons and lids should not

be placed on the hob surface since they can get hot.

 Safety 

instructions

Installation

Warning!

 Only a qualified person must

install this appliance.

• Remove all the packaging.

• Do not install or use a damaged appliance.

• Obey the installation instruction supplied

with the appliance.

• Keep the minimum distance from the other

appliances and units.

• Always be careful when you move the appli-

ance because it is heavy. Always wear safety
gloves.

• Seal the cut surfaces with a sealant to pre-

vent moisture to cause swelling.

• Protect the bottom of the appliance from

steam and moisture.

• Do not install the appliance adjacent to a

door or under a window. This prevents hot
cookware to fall from the appliance when the
door or the window is opened.

• If the appliance is installed above drawers

make sure that the space, between the bot-
tom of the appliance and the upper drawer,
is sufficient for air circulation.

• The bottom of the appliance can get hot. We

recommend to install a non-combustile sepa-
ration panel under the appliance to prevent
access to the bottom.

Electrical connection

Warning!

 Risk of fire and electrical shock.

• All electrical connections must be made by a

qualified electrician.

• The appliance must be earthed.

• Before carrying out any operation make sure

that the appliance is disconnected from the
power supply.

• Use the correct electricity mains cable.

• Do not let the electricity mains cable tangle.

• Make sure the mains cable or plug (if appli-

cable) does not touch the hot appliance or
hot cookware, when you connect the appli-
ance to the near sockets

• Make sure the appliance is installed correct-

ly. Loose and incorrect electricity mains ca-
ble or plug (if applicable) can make the termi-
nal become too hot.

• Make sure that a shock protection is instal-

led.

• Use the strain relief clamp on cable.

• Make sure not to cause damage to the mains

plug (if applicable) or to the mains cable.
Contact the Service or an electrician to
change a damaged mains cable.

• The electrical installation must have an isola-

tion device which lets you disconnect the ap-
pliance from the mains at all poles. The isola-
tion device must have a contact opening
width of minimum 3 mm.

• Use only correct isolation devices: line pro-

tecting cut-outs, fuses (screw type fuses re-

3

www.zanussi.com