Gaggenau VC 230-113 - Инструкция по эксплуатации - Страница 12

10

6.1 Technical data

Pay attention to the "Important notes" (Chapter 1).

The appliance must

only be installed by an

authorised specialist, paying attention to the
relevant regulations of the power supply companies
and the regional construction regulations.

The 

installing technician 

is responsible for

perfect functioning of the appliance at its
installation location. The operation principle must
be explained to the user with reference to the
operating instructions. He must draw the user's
attention as to how to isolate the appliance from 
the mains whenever necessary. 

This cooker corresponds to 

heat class Y

and must

be installed in a cabinet as detailed in the sketch
(Fig. 8). 

When establishing the 

electrical connections

,

make sure that connecting leads cannot come into
contact with hot parts of the cooking surface.
Protection against shock hazards must be ensured
after installation!

Pay attention 

to the data on the rating plate and

connect the PE conductor. Connect the connecting
cable to the mains. The appliance can be
connected with an earthing-pin plug or it can be
connected permanently.

Shock hazard protection

from below must be

ensured after installation, e.g. by the installation of
an intermediate shelf that can only be removed
using tools.

If all poles 

of the appliances cannot be isolated

from the mains by removing an accessible plug (of
a permanent connecting lead), an isolating device
with a contact gap of 

at least 3 mm

must be

installed (e.g. domestic fuse). 

Damages 

caused by failure to observe these

installation instructions cannot be recognised. 

There should be a distance of 

at least 20 mm

between the edge of the appliance and
combustible walls or furniture items.

The distance between the intermediate shelf and
the worktop in which the range is recessed must be

at least 70 mm

.

There should be a distance of 

at least 20 mm

from

the bottom edge of the housing trough and the next
combustible item of furniture.

If installed at an offset above a base cupboard or 
if several appliances from the Vario series are
installed adjacently, the housing can lie on the side
walls of the cupboard.

Note:

please note that a distance of 

10 mm 

from

the cupboard side walls  must be observed for
safety reasons.

This appliance may be installed in kitchen
combinations made of wood or similar combustible
materials without taking additional measures.

Note:

do not stick the cooking surface onto the

worktop with silicone!

6. Assembly instructions