Fulgor Milano CH 604 ID TS WH - Инструкция по эксплуатации - Страница 39

38

39

GB

Independent timer

– If the control unit is activated (the displays 

of all hob zones show [0]), the independent 
timer can be activated by pressing the 
timer selection key. The display shows 0- 
and is ready for setting the first digit of the 
timer. By pressing the timer display, you 
can go on to programming the second digit 
of the timer. The timer is disconnected 
after 10 seconds (blank display) if no 
other settings are made. If a timer value 
is set without the activation of a hob 
zone within 10 seconds, the displays of 
the hob zones are also disconnected). 
The hot hob zones warning lights [H] are 
permanently displayed.

– Until the timer is selected (the dot on the 

display flashes for 10 seconds), it can be 
set. The setting range is 0-99 minutes in 
individual steps, for the Slider area.

– The countdown starts immediately after 

the timer value has been set, starting 
from the last set value.

– The timer is automatically deselected 

after 10 seconds and the time display 
indicates the timer value. Once the set 
time has expired, an acoustic signal is 
activated and the time display shows the 
flashing symbol “00”.

– The beep stops after 2 minutes and/or by 

pressing any button. Subsequently, the 
timer display will stop blinking and switch 
off. Any hot cooking area warning lights 
[H] are displayed permanently.

– By pressing the POWER key, the control 

unit can be switched at any time from the 
“sole timer function” to a hob zone, with 
or without an active independent timer.
If you switch the Touch Control back to 
active mode with an independently active 
timer, first select the independent timer 
highlighted by the active selection “-”; in 
this way you can reset it or change its 
value. If you select a cooking area, the 

“-” on the display disappears and the time 
set on the independent timer is displayed. 
If there is an independent timer set, you 
cannot program a specific timer for a 
cooking area.  Once a hob zone has been 
selected, the decimal point on the timer 
display disappears and a decimal point 
on the hob zone display flashes. When 
the control unit is turned off by means of 
the POWER key, the independent timer 
(if functioning still) is also turned off.

Programming of the specific hob zone 
timer

The power-on of the Touch Control enables 
the timer setting for dedicated hob zones.

– If you activate a cooking area (cooking 

area level > 0) and then select the timer 
display (within 10 seconds), you can 
assign a value of the timer to the cooking 
area as a function of switching off the 
cooking area. The LED corresponding to 
the timer indicates the hob zone for which 
the timer has been activated.

– As soon as the timer is selected, one 

of the LEDs (9) corresponding to the 
cooking area flashes and the timer shows 
“0-” indicating that the first digit of the 
timer can be programmed using the slider 
area. Once you have set the first digit, 
pressing the timer display allows you to 
set the second digit.

– When switching from one hob zone to 

another, the timer display shows the 
current timer value of the related hob 
zone. The timer setting of the other hob 
zones remain active.

– The other settings are the same as those 

for the independent timer.

– If more than one timer is active, the display 

shows the value of the lowest timer (after 
a deselection time of 10 seconds).

– After the set time has expired, an acoustic