Fulgor Milano CH 604 ID TS BK - Инструкция по эксплуатации - Страница 40

40

41

GB

signal is activated and the timer display 
shows the flashing “00” symbol. The 
LED of the corresponding timer flashes 
at the same time. The cooking area 
programmed turns off and the symbol 
“0” is displayed fixed.  The symbol “H” is 
displayed after 10 seconds (deselection 
time) in correspondence with a hot hob 
zone (“hot”). Otherwise the symbol “0” is 
displayed. 

– The acoustic signal and flashing hob 

zone LED stop after 2 minutes and/or 
activating any key.

At this point the displays disappear and the 
hob zone remains deselected.
The behaviour of the specific hob zone timer 
is similar to that of the independent timer.
If a timer is programmed for a hob zone, the 
limitation of the operating time depend on 
the timer value and not on the value of the 
standard table.
The precision of the timer value depends 
on the precision of the clock μC that can 
deviate by +/- 4% in 99 minutes.

Food warmer function (optional)

The food warmer function keeps the food on 
a hob zone warm.
In this case the selected hob zone is 
activated at low power.
When the food warmer function is activated 
for a hob zone, the corresponding display 
indicates the “u” symbol (see symbols).

Activation/Deactivation

The food warming function can also be 
activated as an additional cooking level 
between 0 and 1.
To use the foodwarmer function, select an 
area, set it to 1 using the slider and then 
immediately to 0. For the operating times, 
see the table.

Time limitation of the heat holding 
function

For microbiological reasons, the food 
warming function should not be used for 
excessively prolonged periods (maximum 
1 hour. For this reason the Touch Control 
automatically switches off after 2 hours).

PAUSE 
Activation of the pause function 

When at least one hob zone is functioning, 
the heating elements can be deactivated by 
pressing the Pause key.
The pause display has priority.
The timers that have already been 
programmed (also for the independent 
timer) are stopped and do not function 
during the pause time. The automatic heater 
and booster are also deactivated on all the 
hob zones during the activation, while the 
calculation of the residual heat and the 
limitation of the operating time continues to 
function without being stopped.
The LEDs of the other functions (timer) 
remain on depending on their status.
The pause can last up to 10 minutes. If it is 
not terminated within this time interval, the 
command is deactivated. The hob zone can 
be switched at any time by means of the 
On/Off key. Any active pause functions are 
in this way terminated.

Termination of the Pause function

To terminate the Pause mode and start the 
operation again, the Pause key and any 
other key (not the same key again) must be 
activated within 10 seconds.
In this way the function existing before the 
Pause is re-established. If no other key is 
activated within the 10 seconds, the hob 
zone is also switched off.