Simfer H45V35O517 - Инструкция по эксплуатации - Страница 3

Варочная панель Simfer H45V35O517 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.

Если остались вопросы, задайте их в комментариях после инструкции.

"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Страница:
/ 9
Загружаем инструкцию
background image

90

 cm

 

 

 

 

 

70

 cm

 

 

 

 

 

 

ELECTRICAL CONNECTION and SECURITY

 

1.

 

Your cooker requires a 13 or 16 Amp fuse. If necessary, installation by a qualified electrician is recommended. 

2.

 

Your oven is adjusted in compliance with 230Volt AC, 50 Hz (for SA will be 220-240V,50-60 Hz), electrical 
supply, and requires a 16 Amp (for England 13 Amp) fuse. If the mains are different from this specified value, 
contact an electrician or your authorised service. 

3.

 

Electrical connection of the hob should only be made using sockets with Earth system installed (for England B.S. 
Approved sockets with Earth system), and in compliance with Regulations. If there is no proper socket with Earth 
in place, immediately contact a qualified electrician. The Manufacturer will not be responsible for damage or 
injuries that can arise because of inappropriate supply outlets with no earth system.If the ends of the electrical 
connection cable is open, according to the appliance type, make a proper switch installed in the mains by which 
all ends can be disconnected in case of connecting / disconnecting from / to the mains. 

4.

 

If your electric supply cable gets defective, it should definitely be replaced by the authorized service or qualified                   
electricians in order to avoid from the dangers 

5.

 

Electrical cable shouldn't touch the hot parts of the appliance. 

     
   GAS CONNECTION and SECURITY 

1.

 

Fit the clamp to the hose. Push one of the hose until it goes to the end of the pipe y heating in boiling water, 
and  tighten the clamp with screw driver. 

2.

 

For soundness testing; ensure that the gas controls are closed, 

3.

 

Apply only Approved Leak Detection solutions to the connections for leaks. 

4.

 

If the hob is installed above a cupboard or openable drawer, a heat protection panel must be installed under the      

        hob with a minimum 15 mm clearance

.

 

Caution! Make the oven connection to the gas inlet valve,the hose length must be short and be sure that there is no 
leakage. 

The hose used sholud not be longer than 125 cm for safety. 

RE-INSPECT THE GAS CONNECTION. 

DO NOT MAKE GAS HOSE and ELECTRICAL CABLE OF YOUR COOKER GO THROUGH THE HEATED AREAS, SPECIALLY 
THROUGH THE REAR SIDE OF THE COOKER. DO NOT MOVE GAS CONNECTED COOKER. SINCE THE FORCING SHALL LOOSEN 
THE HOSE, GAS LEAKAGE MAY OCCUR. 
 
 
 

Характеристики

Оцените статью
tehnopanorama.ru
Остались вопросы?

Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)

Задать вопрос

Часто задаваемые вопросы
Как посмотреть инструкцию к Simfer H45V35O517?
Необходимо подождать полной загрузки инструкции в сером окне на данной странице
Руководство на русском языке?
Все наши руководства представлены на русском языке или схематично, поэтому вы без труда сможете разобраться с вашей моделью
Как скопировать текст из PDF?
Чтобы скопировать текст со страницы инструкции воспользуйтесь вкладкой "HTML"