Monsher MHG 61 WG - Инструкция по эксплуатации - Страница 13

13

English

The appliance is fitted with a flame failure safety device on each burner, which 

is designed to stop the flow of gas to the burner head in the event of the flame 
going out.

TO IGNITE A BURNER:

� 

Press in the control knob of the burner that you wish to light and turn it 

anti-clockwise to the maximum position.

� 

If you keep the control knob depressed, the automatic ignition for the burner 

will operate.

� 

You should hold down the control knob for 15 seconds after the flame on 

the burner has lit. If after 15s the burner has not lit, stop operating the device and 
open the compartment door and/or wait at least 1 min before attempting a further 
ignition of the burner.

� 

After this 15-second interval, to regulate the flame you should continue turning 

the control knob anti-clockwise until the flame is at a suitable level. The operating 
position MUST be at a position between the maximum and minimum position.

� 

To switch the burner off, turn the control knob fully clockwise to the gas off 

position.

� 

In case of power failure, the burners can be lit by carefully using a match.