Kuppersbusch EKID 9940.0 RL - Инструкция по эксплуатации - Страница 27

Operation

GB

27

Operation

The hob

The hob is equipped with an induction cooking mode. An
induction coil underneath the glass ceramic hob generates an
electromagnetic alternating field which penetrates the glass
ceramic and induces the heat-generating current in the pot base.
With an induction cooking zone the heat is no longer transferred
from a heating element through the cooking pot into the food
being cooked; instead the necessary heat is generated directly in
the container by means of induction currents.

Advantages of the induction hob

– Energy-saving cooking through the direct transfer of energy to

the pot (suitable pots/pans made of magnetisable material are
required).

– Increased safety as the energy is only transferred when a pot

is placed on the hob.

– Highly effective energy transfer between an induction cooking

zone and the base of a pot.

– Rapid heat-up.
– The risk of burns is low as the cooking area is only heated

through the pan base; food which boils over does not stick to
the surface.

– Rapid, sensitive control of the energy supply.

Pan recognition 

If a cooking zone is switched on and there is no pan on the zone
or if the pan is too small, there will be no transmission of power. A
blinking   in the cooking level display points this out. 
If a suitable pot or pan is placed on the cooking zone, the power
setting will switch on and the power setting display will light up.
The power supply will be cut off when the pan is removed and the
power setting display will indicate a blinking  . 
If a pot or pan placed on a cooking zone is smaller than the
cooking zone and the pan recognition still switches on, only the
amount of power needed will be supplied.

Pan recognition limits

The base of pots and pans must be of a certain diameter; if it is
not, the induction heat will not be switched on.
Always place pots and pans in the middle of a cooking zone in
order to achieve the best efficiency.
Important! The minimum diameter required to activate the pan
recognition device may vary according to the type of pot or pan
used!

Operation time limit

The induction hob has an automatic time limit function.
The duration of continuous use of each cooking zone depends on
the cooking level selected (see chart).
This requires that the setting of a respective cooking zone is not
adjusted during use.
If the operation time limit has been activated, the cooking zone
will switch off, a short signal will sound and an H will appear in
the display.
The automatic switch-off function overrules the operation time
limit, i.e. the cooking zone is only switched off when the period of
time of the automatic switch-off device has expired (e.g.
automatic switch-off after 99 minutes and cooking level 9 is
possible).

Other functions

If two or more sensor keys are pressed at the same time (e.g.
when a pan is mistakenly put onto a sensor key) no function will
be activated.
The   symbol will blink and a time-limited continuous signal will
sound. After a few seconds the appliance will switch off. Please
remove the item located in front of the sensor keys.
To delete the   symbol press the same key or switch the hob off
and on.

Protection against overheating 
(induction)

If the hob is used at full power for a longer period, it will not be
possible to cool down the electronics system as required at a
high room temperature.
In order to ensure that no excessive temperatures occur in the
electronics system the power of the cooking zones may be
reduced automatically.
Should E2 be displayed frequently during normal use of the hob
and at normal room temperature, it is likely that cooling is not
sufficient.
This may occur if kitchen units have no openings. The installation
may have to be checked.

Cooking zone dimension

(mm)

Recommended pan base 

minimum diameter (mm)

220 x 190 

115

Selected cooking 

level

Operation time limit in 

minutes

1

2
3
4
5
6
7
8
9

P

120
520
402
318
260
212
170
139

113

90
10