Kuppersberg FV3TG X - Инструкция по эксплуатации - Страница 16

16

Technical passporT

english

gas hob

If the fl ame is gone when you release 

the switch You should repeat the above 
process. But this time press the switch 
and hold for about 10 seconds. 

WARNING; 

Do not use burning system more 

than 15 seconds. If the burner will not be 
burned within such time or if the fl ame 
will be cut for any reason whatsoever, 
repeat burning process after waiting for 
1 minute. 

Closing the burners 

Turn the control switch right-wise to 

close the hob. 

Flame Failure Device (FFD) 

All burners on your hob are 

equipped with Flame Failure Device 

system against fl ame extinguishing risk 
(water  fl ow,  wind  etc.)  When  the  fl ame 

was gone while the burner switch is 
open such system will prevent cutting 
of the gas supplied to the burner. If the 
burning of the burner will be cut due 
to safety, repeat the burning operation 
by switching the burner switch to off 
position.

Figure 8.

7.2.2. FOR HOT-PLATE BURNER 
Warnings 

Before use of electrical plate 

the plate should be elevated to the 
maximum level and rest it for 5 minutes 
without putting any container thereon. 
It is Ok if any smell or smoke will 
rise from the plate. Such effects shall 
disappear after starting normal use. 

After  such  fi rst  use  do  not  operate 

the electrical plate without any 
container thereon. 

Use the containers with the bottoms 

being thick and suitable for the plate 
size. Never use smaller sole containers. 

Pay attention that no liquid and wet 

containers will be placed on the plate. 

Avoid any contact of any vinegar, 

salt, lemon juice etc. with the plate. Do 
not use any spatula and similar sharp 
objects in cleaning of joints between the 
glass and metal surfaces or aluminum 
parts on the hob. 

7.3. BASIC SETTINGS

Power control switch

Electrical plate is managed with 

a switch with which you may select 
proper power for the food you will cook.