Kuppersberg FS 62 B - Инструкция по эксплуатации - Страница 30

30

TECHNICAL PASSPORT

ENGLISH

Built - in cooker

2.3 Wiring

  You should definitely use an earthed 

line for the product!

The  manufacturing  firm  shall  not  be 

responsible for any damages that may occur if 

the product is used without the earth. 

 ОElectric shock, short-circuit or fire risk 

arising from the installation performed by any 

unprofessional persons! The product should be 

connected to the mains only by an authorized 

and  qualified  person  and  the  warranty  of  the 

product starts only after correct installation. 

  Power  shock,  short-circuit  or  fire  risk 

arising from damaged power cable! The power 

cable  should  be  crushed,  crinkled  or  pinched 

or should not contact with the hot parts of the 

product.  If  the  power  cable  gets  damaged,  it 

should be replaced by a qualified electrician. 

• 

The  mains  supply  data  should  be 

same on the data indicated on the nameplate 

of the unit. You may find the nameplate at the 

back of or under the product. 

•  The connection cable of the 

product  should  comply  with  the  technical 

specifications and power consumption. 

 Risk of electric shock! Before performing 

any  work  on  the  electric  installation,  please 

disconnect the power supply of the product.

2.4 Gas connection 

Â

Any  work  on  the  gas  equipment 

and  systems  should  be  performed  by      the 

qualified and authorized persons. 

Â

Prior to installation, make sure the 

conditions  of  local  distribution  (gas  type 

and  gas  pressure)  comply  with  the  settings 

of the product. 

2.4.1  LPG connection

Â

Make sure the gas hose and gas 

pressure-reducing  valve  you  use  on  the 

range are safe. Connect the gas delivery 

hose with the hose behind the range and 

tighten it by using a clamp and screwdriver 

(figure 10). Make sure it is firmly tightened. 

Â

Gas  delivery  hose  of  the  equipment 

should not be longer than 1500mm. 

Â

The  pressure  of  the  pressure-

reducing valve to be used for LPG should be 

300mmSS and certificated. 

 Gas delivery hose should not pass 

through the hot part behind the equipment. 

Temperature of the gas hose should not 

exceed 90°C (degree). 

Prior to use, make sure the system does 

not leak any gas.

1. 

G1/2 Nipple)

2.  Silicon seal

3.  G1/2 Hose inlet ( gas inlet)

4. 

Metal clamp

5.  Gas hose (inner diameter 8mm)