Kaiser KCT3426 - Инструкция по эксплуатации - Страница 40

EN 

Timer programming on cooking zones 

 
 
When the control is switched-ON an independent 
timer can be programmed for every cooking zone. 
 
 

x

  By selecting a cooking zone with the cooking-

zone-selectkey, then selecting the setting and 
finally activating the timerselect- key 

1

, the 

timer can be programmed as a switch-off 
function for a cooking zone.  

 
 
Around the timer four LEDs are arranged.  
 
These indicate for which cooking zone the timer has 
been activated.  
As soon as the timer has been selected, the 
assigned timer - LED 

2

blinks and the dot in the 

timer display 

3

 glows.  

 
If a cooking-zone-select-key 

4

 will be operated, the 

dot in the timer displays extinguishes and the LED 
does not blink any longer. 
 
When switching-over from one cooking zone to 
another, the timer display always shows the present 
timer value of the respective cooking zone.  
 
However, the programmed timers of other cooking 
zones remain active. 
 
The further setting behaviour corresponds to the 
“Timer as countdown tmer”.  
For increasing the adjusted time, the (

+

)-key 

4

 of the 

respective cooking zone has to be used. 
 
 
When the timer has run down, there is a sound signal 
and the timer display shows “00“ statically, the 
assigned cooking zone timer LED 

2

blinks.  

 
 
The programmed cooking zone will be cut off and „H“ 
will be displayed if the coking zone is hot, otherwise 
a stroke will show in the cooking zone display. 
 
The sound signal will be stopped automatically after 
2 minutes and/or by operating any key.  
 
 
The timer display extinguishes. 
 
The basic behaviour follows the description of the 
„Timer as minute minder”. 

3

1

2

4

40