Kaiser KCG 6335 RotEm Turbo - Инструкция по эксплуатации - Страница 6

6

GB

INSTRUCTIONS FOR USE 

INSTALLATION

All the operations concerned with the installation 
(electrical connection) must be carried out by 
qualified technicians, in terms with the standards in 
force. For specific instructions, kindly read the part 
reserved for the installation technician. 

USE

Gas burners 

(Fig. 1-3-3a-3b). The ignition of the 

gas burner is carried out by putting a small flame 
to the upper part holes of the burner, pressing and 
rotating the corresponding knob in an anti-
clockwise manner, until the maximum position has 
coincided with the marker. When the gas burner 
has been turned on, adjust the flame according to 
need. The minimum position is found at the end of 
the anti-clockwise rotation direction. In models with 
automatic ignition, operate the knob as described 
above, pressing simultaneously, the corresponding 
push-button. For models with 
automatic/simultaneous (with one hand) ignition, it 
is sufficient to proceed as described above using 
the corresponding knob. The electric spark 
between the ignition plug and the burner provides 
the ignition of the burner itself. After ignition, 
immediately release the push-button and adjust 
the flame according to need. 
For models with a thermoelectric safety system, 
the burner is ignited as in the various cases 
described above, keeping the knob fully pressed 
on the maximum position for approximately 3/5 
seconds. After releasing the knob, make sure the 
burner is actually lit. 
N.B. - we recommend the use of pots and pans 
with a diameter matching that of the burner, thus 
preventing the flame from escaping from the 
bottom part and surrounding the pot 

-

 do not leave any empty pots or pans on the fire 

-

 do not use any tools for grill-cooking on Crystal 

hobs.
When cooking is finished, it is also a good norm to 
close the main gas pipe tap and/or cylinder.