Electrolux EHH 6540 FOK - Инструкция по эксплуатации - Страница 14

Problem

Possible cause

Remedy

The heat setting changes

between two levels.

Power management func-

tion operates.

Refer to "Daily use" chapter.

The sensor fields become

hot.

The cookware is too large

or you put it too near to the

controls.

Put large cookware on the

rear zones if possible.

There is no signal when you

touch the panel sensor

fields.

The signals are deactivated. Activate the signals.

Refer to "Daily use" chapter.

 comes on.

Automatic Switch Off oper-

ates.

Deactivate the hob and ac-

tivate it again.

 comes on.

The Child Safety Device or

the Lock function operates.

Refer to "Daily use" chapter.

 comes on.

There is no cookware on

the zone.

Put cookware on the zone.

The cookware is incorrect.

Use the correct cookware.

Refer to “Hints and tips”

chapter.

The diameter of the bottom

of the cookware is too small

for the zone.

Use cookware with correct

dimensions.

Refer to “Technical informa-

tion” chapter.

 and a number come on. There is an error in the hob. Disconnect the hob from

the electrical supply for

some time. Disconnect the

fuse from the electrical sys-

tem of the house. Connect
it again. If   comes on

again, speak to an Author-

ised Service Centre.

 comes on.

There is an error in the hob

because a cookware boils

dry. Automatic Switch Off

and the overheating protec-

tion for the zones operate.

Deactivate the hob. Re-

move the hot cookware. Af-

ter approximately 30 sec-

onds, activate the zone

again. If the cookware was

the problem, the error mes-

sage goes out. Residual

heat indicator can stay on.

Let the cookware become

sufficiently cool. Check if

your cookware is compati-

ble with the hob.

Refer to “Hints and tips”

chapter.

www.electrolux.com

14