Candy CFX 75 P - Инструкция по эксплуатации - Страница 7

07 GB

3. USE OF HOB - USER INSTRUCTIONS

This appliance must only be used for the purpose for which it is 
intended, domestic cooking, and any other use will be considered 
improper and could therefore be dangerous. The Manufacturer will 
not be responsible for any damage or loss resulting from improper 
use.

3.1. USING THE GAS BURNER

To ignite the burners, place a lighted taper close to the burner, press in 
and turn the control knob anti-clockwise.
If the burners have not been used for a couple of days, wait for a few 
seconds before lighting the burner, this will allow any air present in the 
pipes to escape.
For appliances fitted with electronic ignition carry out the following:
• push in and turn the knob anticlockwise to the ignition symbol.
• ignite the burner by pressing the sparker button.
For hobs fitted with automatic ignition simply push in and turn the knob 
to the ignition symbol.
The ignition system will continue to generate sparks as long as the 
control knob is being pressed.
If the burner has not ignited within 5 seconds, turn the knob to the 0 
position and repeat the operation.
For models fitted with a safety tap (which cuts-off the flow of gas if the 
flame is accidentally extinguished) the burners are ignited and 
described above, but care must be taken.
Prior to switching on the gas hob ensure that the burners and burner 
caps are correctly placed within their position.

GENERAL ADVISE

For best results, use cooking vessels with a flat surface.   The size of 
the surface should match the gas burner side as follows. Table A. 

For smaller containers the gas burner should be regulated so that the 
flame does not overlap the base of the pan. Vessels with a concave or 
convex base should not be used.

WARNING: If a flame is accidentally extinguished, turn the knob 
to the off position and do not attempt to re-ignite if for at least 1 
minute.

If over the years the gas taps become stiff to turn it is necessary to 
lubricate them.

Such operation must be carried out only by qualified Service 
Engineers.

To prevent any potential damage to the hob please carry out the 
installation following this sequence (picture 6):

 1)As illustrated, assemble parts in sequence:

A: 1/2 Male Adaptor Cylindirical
B: 1/2 Seal
C: 1/2 Female Gas Adaptor Conical-Cylindirical or 
     Cylindirical-Cylindirical

2)Tighten the joints with the spanner, remembering to twist the 
pipes into position.

3)Attach fitting C to mains gas supply using rigid copper pipe or 
flexible steel pipe.

IMPORTANT: carry out a final check for leaks on the pipe 
connections using a soapy solution. NEVER USE A FLAME. Also, 
make sure that the flexible pipe cannot come into contact with a 
moving part of the cabinet (eg.adrawer) and that it is not situated 
where it could be damaged.

Warning: 

If gas can be smelt in the vicinity of this appliance turn off the 

gas supply to the appliance and call the engineer directly. Do not 
search for a leak with a naked flame.

Table A

Auxiliary

Semi Rapid

Rapid Rear 

Burner Type

Ø pan / pot 

Max(cm)

AUX 
SR
R 

18

22

22

Ø pan / pot 

Mın (cm)

10

12

20

4. MAINTENANCE AND CLEANING

Before cleaning the hob, ensure the appliance has cooled down. 
Remove the plug from the socket or (if connected directly) switch off 
the electricity supply.

Cleaning and user maintenance shall not be made by children without 
supervision.

Never use abrasives, corrosive detergents, bleaching agents or 
acids. Avoid any acid or alkaline substances (lemon, juice, vinegar 
etc.) on the enamelled, varnished or stainless steel sections.

When cleaning the enamelled, varnished or chrome sections, use 
warm soapy water or a non caustic detergent. For stainless steel use 
an appropriate cleaning solution. 

The burners can be cleaned with soapy water. To restore their original 
shine, use a household stainless steel cleaner. After cleaning, dry the 
burners and replace.

It is important the Burners are replaced correctly.

Chromed or Stainless Steel

grids and burners

Chromed or Stainless Steel

grids and burners have a tendency to 

discolour with use.   This does not jeopardize the functionality of the 
hob. 

Our After Sales Service Centre can provide spare parts if required.

5. AFTERCARE

Before calling out a Service Engineer please check the following:
• that the plug is correctly inserted and fused;
• that the gas supply is not faulty.

If the fault cannot be detected:
Switch off the appliance and call the After Service Centre.  DO NOT 
TAMPER WITH THE APPLIANCE.

This appliance is marked according to the European 
directive 2012/19/EU on Waste Electrical and 
Electronic Equipment (WEEE). WEEE contains both 
polluting substances (which can cause negative 
consequences for the environment) and basic 
components (which can be re-used). It is important to 
have WEEE subjected to specific treatments, in order 
to remove and dispose properly all pollutants, and 

recover and recycle all materials.
Individuals can play an important role in ensuring that WEEE does not 
become an environmental issue; it is essential to follow some basic 
rules:
• WEEE shall not be treated as household waste.
• WEEE shall be handed over to the relevant collection points 
managed by the municipality or by registered companies. In many 
countries, for large WEEE, home collection could be present.
• When you buy a new appliance, the old one may be returned to the 
retailer who has to collect it free of charge on a one-to-one basis, as 
long as the equipment is of equivalent type and has the same 
functions as the supplied equipment.

6. PROTECTION OF THE ENVIRONMENT

The Manufacturer will not be responsible for any inaccuracy resulting from 
printing or transcript errors contained in this brochure. We reserve the right 
to carry out modifications to products as required, including the interests of 
consumption, without prejiudice to the characteristics relating to safety or 
function.

Declaration of compliance:

 This equipment, in the parts intended to 

come into contact with food, complies with the regulations laid down in 
EEC directives 89/109.
The appliance complies with European Directives 2009/142/EC and 
subsequent amendments.

By placing the         mark on this product, we are confirming 
compliance to all relevant European safety, health and environmental 
requirements which are applicable in legislation for this product.

Rapid Center

R 

26

20