Увлажнители VITEK VT-1761 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.

•
Крышка емкости для воды должна быть плотно закрыта.
•
Перед тем, как приступить к сливу воды из емкости, прибор следует
отключить от сети электроснабжения.
•
Не прикасайтесь к излучателю ультразвука руками или
инструментами.
•
Не ходите босиком во время работы увлажнителя.
•
Во время отключения от сети электроснабжения не тянуть за шнур
или за прибор.
•
Беречь от атмосферных осадков.
•
Не касайтесь работающего прибора мокрыми руками. Не заливайте
горячей водой!
ОСНОВНЫЕ ДЕТАЛИ
Рис. 1
1. Насадка для выпуска пара.
2. Вращающаяся головка.
3. Переносная ручка.
4. Емкость для воды.
5. Основной корпус.
6. Кнопка "Вкл./Выкл".
7. Регулятор потока.
8. Шнур электроснабжения.
РУССКИЙ
8
MAINTENANCE AND CLEANING
Before any cleaning operation, switch the apparatus off and unplug it.
1. There may be some lime deposits in the transducer, particular in areas with
hard water. Overcome this drawback by cleaning the transducer with water
and vinegar on a soft cloth at least once a week, as follows:
a) Dampen a cloth with vinegar and wipe the transducer gently, until
the lime deposits disappear completely.
b) Rub down with a dry cloth and remove remains of humidity.
c) Do not rub the transducer with solid objects.
d) Do not clean with chemical products.
2. Clean the inside of the water tank at least once a week, as follows:
a) Fill the tank with clean water adding a few drops of bleach. Close the
tank completely with its cap and forcibly.
b) Rinse thoroughly.
c) If lime deposits are noted in the tank, dean with vinegar and v and rub
down with a clean soft clothe. Then rinse with clean water the lime deposit
has affected the water level float in the central clean it with a soft cloth.
Note:
Water accumulated over long periods may create bacteria mildew (fun-
gus).
3. Clean all the humidifier parts and then dry them well before storing appa-
ratus in its box.
4. With each change of water the use is recommended of the included, to
remove dust and any lime remains on the transducer.
5. Do not place the transducer directly under the tap.
Water must not get into the apparatus; should that happen, take it the autho-
rised assistance centre before using it again.
TROUBLESHOOTING
Do not try to open the apparatus: there is a risk of electrocution.
ENGLISH
5
Vt-1761.qxd 02.12.03 18:37 Page 10
Содержание
- 3 УХОД И ЧИСТКА; Долгое пользование воды может привести к; MAIN COMPONENTS; ENGLISH
- 5 ОСНОВНЫЕ ДЕТАЛИ; MAINTENANCE AND CLEANING
- 6 SERVICE LIFE OF THE HUMIDIFIER NOT LESS THAN 3 YEARS