Stadler Form O-041R Oskar Big - Инструкция по эксплуатации - Страница 6

• Do not place the appliance near a heat source. Do not subject the power 

cord to direct heat (such as a heated hotplate, open flames, hot iron sole 
plates or heaters for example). Protect power cords from oil.

• See to it that the appliance is properly positioned to ensure a high stabil-

ity during its operation and make sure that no one can trip over the power 
cord.

• The appliance is not splash-proof.

• For indoor use only.

• Do not store the appliance outdoors.

• Store the appliance in a dry place inaccessible to children (pack the ap-

pliance).

• If the power cord is damaged, it must be replaced by the manufacturer 

or a repair shop authorized by the manufacturer or by similarly qualified 
persons in order to avoid a hazard.

Setting up / operation

1. Place Oskar big on a flat surface in the desired area. Plug the mains cable 

(3) into a electric socket. Use the filling opening (11) to fill the lower part 
(2) with water up to the maximum mark (14), either at a water tap or with 
a watering can. When you have filled the lower part at the tap, carefully 
fit the upper part (1) to the lower part (2).

2. Start the appliance by pressing the on/off switch (5). The blue LED should 

then light up. If a red pilot lamp (10 and 14) lights up however, this indi-
cates either lack of water in the appliance or failure to seat the upper part 
correctly on the lower part. If there is no water in the appliance, the motor 
will stop automatically.

3. By pressing the speed level selector button (6) you can change the humid-

ity output (1 to 4 LEDs = normal evaporation to high evaporation).

4. You can use the hygrostat to set the desired air humidity. To do this, press 

on the hygrostat button (7). You can choose between the following lev-
els: 40 % relative air humidity (1 blue LED), 45 % (2 blue LED), 50 % (3 
blue LED), 55 % (4 blue LED), constant operation (5 blue LED). If the lamps 
are flashing, this indicates that the desired air humidity has already been 
reached. Please note that the hygrostat needs about 3 second to measure 
the current humidity in the room. The hygrostat switches on automatically 
once the relative air humidity in the room sinks below the preset value. 
We recommend that you set your room humidity to 45 % (comfort range).

5. If you find the lamps too bright (in a bedroom for example), you may reduce 

the light intensity by pressing the night mode key (8). You can choose 
between three different modes:

• Normal mode (default mode)

• Dimmed mode (push once)

• Lights-out mode (push twice)

• By pushing the dimmer button once more, you can go back into normal 

mode.

If there is no water in the appliance, the red LEDs (10 and 14) light up in all 
modes (normal and night mode). The red light can not be dimmed.

6. Oskar big has a reminder function for filter change. At first use timer will 

be set automatically. After a whole operating duration of two months the 
filters need to be changed. In this case, the blue LED above the reset but-
ton (9) is blinking. After changing the filters, press the reset button (9) for 
5 seconds until the blue LED is fully lighted again.

Congratulations! You have just purchased the exceptional humidifier  
OSK AR big. It will give you great pleasure and improve the indoor air for you. 

As with all domestic electrical appliances, particular care is needed with 
this model also, in order to avoid injury, fire damage or damage to the appli-
ance. Please study these operating instructions carefully before using the 
appliance for the first time and follow the safety advice on the appliance 
itself.

Description of the appliance

The appliance consists of the following main components:
  1.  Upper part of air humidifier with motor
  2.  Lower part of air humidifier (water container)
  3.  Mains cable for electricity supply
  4.  Zinc base
  5.  On/off switch 
  6.  Speed level selector button 
  7.  Hygrostat operation button 
  8.  Night mode button
  9.  Reminder function for filter change
 10.  «No water» indicator
 11.  Opening for refilling while in operation
 12.  Fragrance  container
 13.  Filter  cassettes
 14.  Maximum mark / water level indicator
 15.  Ionic Silver Cube™

Important safety instructions

Please read through the operating instructions carefully before you use the 
appliance for the first time and keep them safely for later reference; if nec-
essary pass them on to the next owner.

• Stadler Form refuses all liability for loss or damage which arises as a 

result of failure to follow these operating instructions.

• The appliance is only to be used in the home for the purposes described 

in these instructions. Unauthorised use and technical modifications to the 
appliance can lead to danger to life and health.

• This appliance can be used by children aged from 8 years and above and 

persons with reduced physical, sensory or mental capabilities or lack of 
experience and knowledge if they have been given supervision or instruc-
tion concerning use of the appliance in a safe way and understand the 
hazards involved. Children shall not play with the appliance. Cleaning and 
user maintenance shall not be made by children without supervision.

• Only connect the cable to alternating current. Observe the voltage infor-

mation given on the appliance.

• Do not use damaged extension cords.

• Do not run the power cord over sharp edges and make sure that it does 

not get trapped. Do not pull the plug from the socket with wet hands or by 
holding on to the power cord.

• Do not use the appliance in immediate vicinity of a bath tub, a shower or a 

swimming pool (observe a minimum distance of 3 m). Place the appliance 
such that a person in the bath tub cannot touch the appliance.

English