Stadler Form Julia - Инструкция по эксплуатации - Страница 11

• Do not place the appliance near a heat source. Do not subject the power 

cord to direct heat (such as a heated hotplate, open flames, hot iron sole 
plates or heaters for example). Protect power cords from oil.

• See to it that the appliance is properly positioned to ensure a high stabil-

ity during its operation and make sure that no one can trip over the power 
cord.

• The appliance is not splash-proof.

• For indoor use only. 

• Do not store the appliance outdoors.

• Store the appliance in a dry place inaccessible to children (pack the ap-

pliance).

• If the power cord is damaged, it must be replaced by the manufacturer 

or a repair shop authorized by the manufacturer or by similarly qualified 
persons in order to avoid a hazard.

• Only use fragrances, aromas or essential oils that do NOT contain alcohol. 

Alcohol can damage the appliance. Appliances that are damaged by such 
additives are not covered by the warranty.

Setting up / operation

1.  Place Julia at the desired location on a flat surface. Connect the network 

adapter (1) to the device (2) and plug the adapter into a suitable socket. 

2.  Lift off the upper part (3) and the mist outlet/lid (4) in order to fill with 

water and fragrances.

3.  Fill the water container (5) up to the maximum mark (MA X) (6) with wa-

ter. Important: please do not carry Julia around whilst she is filled with 
water. The water could run into the electronics.

4.  Add 2–3 drops of your favourite liquid fragrance directly into the water. 

It is not necessary to mix them as the ultrasound membrane (7) does 
this for you. Only use fragrances, aromas or essential oils that do NOT 
contain alcohol.

5.  Put the lid (4) and the upper part (3) back on the water container (5). In 

doing so, make sure that the lid and the upper part are correctly posi-
tioned (lid: fit the rear cutout onto the lower part; upper part: fit the 
opening in the middle of the indentation onto the guide bar in the water 
container).

6.  Then switch Julia on by pressing the on/off button (8). Important: Only 

switch Julia on if you have placed both the mist outlet/lid (4) and the 
upper part (3) on the water container (5). Once Julia has been switched 
on, the LEDs to the right of the on/off button light up. If this does not 
happen, check whether there is sufficient water in the device or check 
whether the adapter has been connected to the power supply. With a 
full water container (up to the MA X mark), the runtime is approx. 18 h 
and 54 h in interval mode.

7.  The output level can be adjusted by re-pressing the on/off button (8) on 

the front of the device: two LEDs for the higher level and one LED for 
the lower level (9).

8.  Interval mode makes it possible for you to run the aroma diffuser for 

approx. 54 h at the output level without having to refill it again. Press 
the button for interval mode (10). The LED to the right of the interval 
button (11) lights up if interval mode has been switched on. Julia will 
now diffuse fragrance into the room for 10 minutes. The appliance will 
then switch off for 20 minutes. This mode means it is possible to diffuse