Stadler Form Ben - Инструкция по эксплуатации - Страница 12

water tank (3) sideways again, diagonal to Ben, and lift the water tank up 
and insert it again. Important: Please do not move Ben when it is filled 
with water. The water could splash out of the interior tank and into the 
electronics.

3. Next, start Ben by pressing the On/Off button (6). The LEDs for the fire-

place effect will then light up, and the mist will be visible as it comes out 
of the appliance (7) at variable output controller (8) height.

4. By turning the variable output controller (8), you can adjust the humidifier 

output as you wish.

5. If you are disturbed by the brightness of the illuminated mist (in the bed-

room, for example), you can reduce the brightness of the LEDs by pressing 
the dimmer button (9). You can choose between three different modes:

• Normal mode (default mode)

• Dimmed mode (push once)

• Lights-out mode (push twice)

• By pushing the dimmer button once more, you can go back into normal 

mode.

6. You can also use Ben to fragrance the room. We ask that you be sparing 

when dealing with fragrances as too much can lead to malfunctions and 
damage to the unit. To use fragrances, remove the water tank (3) from the 
unit and trickle the fragrance directly into the water tray (10) (see page 5). 
Add a maximum of 2–3 drops of fragrance per full tank of water. Install 
the water tank back into the unit.

Tip:

 Would you like to change the fragrance? Remove the water tank 

from the unit, pour the remaining water out and clean the humidifier (see 
«Cleaning»). Now Ben is ready to distribute a different fragrance of your 
choice around the room. The intensity with which the aroma is diffused 
can be adjusted smoothly by sliding the variable output controller.

7. The water level indicator (11) glows red when the water needs to be re-

filled. Remove the water tank (3) and fill it up with tap water. Replace the 
water tank. The appliance will resume operation after a few seconds.

8. Would you like to refill the water during operation? You can simply remove 

the water tank (3) and fill it up. The unit will operate for around a further 
5 to 10 minutes with the water that remains in the system. Put the water 
tank back into the unit within this time period and Ben can continue opera-
tion without stopping at all.

Note: 

Should you see droplets (or other signs of dampness) on or around 

the unit, this is condensed water from the humidifier. This means that the 
air can no longer absorb the moisture from the humidifier. Please reduce the 
humidifier output until you can no longer see any droplets.

Cleaning 

Before each piece of maintenance and after every use, turn off the unit 
and remove the plug from the plug socket. Before you clean Ben, the power 
adapter (1) must be separated from the power adapter connection (2).

Attention:

 Never submerge the unit in water (danger of short circuiting).

• For hygienic reasons and to ensure proper operation, we recommend the 

following cleaning intervals.

•

Daily:

 Fill the water tank (3) with fresh, cold tap water. If the appliance 

is not used for several days, empty the water from the water tray (10) be-