Timberk THU UL 14 E - Инструкция по эксплуатации - Страница 5

www.timberk.com • electric humidifier

5

Air ionization function

To turn the air ionization function on or off, press the --- button. When 

the button is pressed, the negative ion generator turns on / off, and the 

ionization indicator on the control panel lights up / goes out.

The ionizer generates negatively charged ions (anions) and refreshes the 

air in the room. Anions strengthen the nervous and circulatory system, 

improve lung function and serve as effective protection against respiratory 

diseases (such as asthma and pneumonia). Anions clean the air of dust 

and smoke.

Humidity control function

When this function is activated, the device will automatically turn off when 

reaching the set humidity level (more than 3%) and automatically turn on 

when the humidity level falls below the set humidity level.

To activate the humidity control function, press the --- button. The display 

shows the set humidity value. Continue to press the --- button to set the 

desired humidity level from 20% to 85% in 5% increments and select the 

desired humidity level. After setting, the set value flashes in the display for 

3 seconds, after which the value of the current humidity is displayed. Press 

6.APPLIANCE OPERATION

1 

15

10

14

11

13

12

9

2

8

3 

5 

4

6 

7

1.   Power  on / off button
2.   Steam output selection button: low, medium, high
3.   Automatic power on / off button
4.   Symbol of humidity
5.   Automatic mode indicator
6.   Steam output indicators
7.   Button setting the desired level of humidity from 20 to 85%
8.   Set timer button to turn off the device
9.   Air ionization on / off  button 
10. Timer indicator
11. Air ionization indicator
12. The display
13. Indicator of absence of water
14. The symbol of the hour
15. Light indication of operating modes

Switching the device on

Fill the reservoir with water and install the device vertically on a flat, dry 

surface, then connect the appliance to the mains by inserting the plug of 

the power cord into an outlet.

Press --- button, the device will automatically start to work and the display 

will show the steam output indicators, the current humidity value, and the 

mode light will light around the control panel.

At the very beginning of the work, the level of spraying can be unstable, 

due to the difference in temperature and water quality. It will take some time 

for the water to vaporize on the ultrasonic membrane, and this process 

has stabilized. After 10-25 minutes of operation, the spray level gradually 

stabilizes.

Steam output intensity adjustment

In order to change the intensity of the steam output, press the button --- 

several times, the intensity of the steam output will change: low, medium, 

high, and accordingly the intensity of the steam output will be indicated by 

the indicators on the display and the intensity of the light indications of the 

modes around the control panel.

Comfortable conditions are achieved with a relative humidity of 40 to 60%.

ATTENTION!  

If the device generates a large amount of condensate 

on the top of the device and on objects near it, it is 

necessary to reduce the intensity of the steam output.