Timberk THU MINI 02 - Инструкция по эксплуатации - Страница 6

www.timberk.com • electric humidifier

6

8. CLEANING AND SERVICING THE UNIT

IMPORTANT!

When the unit is operating, you must not remove the 

water tank or the upper cover until there is water in them. 

Otherwise, the water level inside the unit will rise, which may 

cause its failure or malfunction (steam will stop outflowing). 

To resume the operation in case of malfunction, disconnect 

the unit from the power line and drain water. Important! 

Drain water from the unit only towards the atomizer’s spout 

(i.e. to the right, when looking at the on/off regulator).

Prior to cleaning the unit make sure the power supply’s plug is disconnected 

from the outlet. Otherwise, it may cause electric shock.
Prior to cleaning remove the case cover and wait until water, remaining in 

the unit’s case, completely cools down.
Clean the unit once or twice a week.
8.1. Use a damp and soft fabric to wipe internal surface of the unit.
To avoid electric shock do not scratch or damage elements of the unit 

when cleaning.
When cleaning, do not use solvents, benzene, xylene, scrub brush, talc 

powder and other substances except for water.
8.2. Wipe off remains of water inside the unit’s case using a damp and 

soft fabric.
To wipe of remains of water on small parts you can use a soft brush and 

then wipe them with a soft fabric again.
8.3. In case of dirt (scale) on the membrane, clean it with a soft brush.

IMPORTANT!

To avoid deformation or wear of working surfaces, 

resulting in decreased atomizing or other malfunctions, 

do not use metallic brushes, blades or talc powder to 

wipe the atomizer’s surface.
In case of water leakage, immediately stop using the unit 

and contact a service center.
To keep the unit dry, remove water after cleaning and 

make sure to dry the unit’s case.
Make sure that there is no water left inside the unit’s 

case.
Prior to a long break in using the unit, dry its surface and 

pack it into a plastic bag, then put it into a box.
Store the unit in a low-humidity room.
Storing the unit undried results in generation of mold.

NOTE:

When using the humidifier, you may come across 

condensate generation of objects next to it, including 

water accumulation, which is not a defect, but a feature 

of its operation. This feature may have several causes, 

listed in table 2 on page 7.

8.4. Use a soft brush to wipe off remains of water on the surface of the 

atomizer’s nozzle, and then wipe it with a soft fabric again.
8.5. Clean the water intake and the atomizer with clean water, as well as 

the case cover. Do it carefully and lightly.
After removing water from the atomizer’s surface clean it with a soft fabric. 

Clean the unit’s external surface with a damp and soft fabric.