Zelmer ZIR1505 - Инструкция по эксплуатации - Страница 13

13

PL

EN

Shot of steam 

The shot of steam feature provides additional steam for removing stubborn wrinkles.
Set the temperature control to at least the “●●” position.
Press the powerful steam button to release the burst of steam.

NOTE: 

To prevent water leakage from the soleplate, do not keep the powerful steam button in 

continuously and wait almost 5 seconds between pressures

.

Vertical ironing 

Set the temperature control to “max”.
By pressing the shot-steam button at intervals you can also iron vertically (curtains, hung garments, etc.)

NOTE: 

To prevent water leakage from the soleplate, do not keep the powerful steam button in 

continuously and wait almost 5 seconds between pressures

.

When you finished ironing

Set the temperature dial to the minimum position.
Remove the main plug from the wall socket.
Stand the iron on heel rest.

MANITENANCE AND CLEANING

It is recommended to do the self-cleaning every two weeks if the water in the area is hard or semi-hard if 

frequent use of the device is made
Before cleaning the steam iron ensure it is unplugged from the power supply and has completely cooled 

down.
Do not use abrasive cleaners.
To clean exterior surfaces, use a damp soft cloth and wipe dry. Do not use any chemical solvents, as 

these will damage the surface.
Cleaning the soleplate; Do not use scouring pads or harsh cleaners on the soleplate as these will 

damage the surface. To remove burnt residue, iron over a damp cloth while iron is still hot. To clean the 

soleplate, simply wipe with soft damp cloth and wipe dry.

Self-cleaning

1. Unplug the iron from the mains socket
2. Set the steam regulator to the 

 position.

3. Fill the water reservoir.
4. Set the temperature control to its maximum position.
5. Insert the main plug into the wall socket.
6. Allow the iron to heat up until the indicator light turns off.
7. Unplug the steam iron (very important!)
8. Hold the iron over a sink. Press the “clean” button and shake the iron until approximately one third of 

the water capacity of the tank is evaporated. Boiling water and steam will be ejected from the holes in 

soleplate with impurities washed out 

9. Release the “clean” button, and gently shake the iron for some seconds.
10. Repeat the steps 8 and 9 three times until the tank is empty.
11. Then plug the iron in and heat it up again until the remaining water has evaporated.
12. Push the “clean” button a few times more to clean the valve.
13. Unplug the iron and let the soleplate cool down.
14. Move the iron over an old (preferably) piece of cloth. This ensures that the soleplate will be dry during 

storage. 

It is recommended to do the self-cleaning at least every two weeks.
Please note: