VITEK VT-1262 PK - Инструкция по эксплуатации - Страница 6

6

 ENGLISH

experimentally• (always• start• with• the• lowest•
temperature•and•raise•it•gradually•until•you•get•
the•desired•result).

•

Corduroy•and•other•fabrics•that•become•glossy•
quickly• should• be• ironed• strictly• in• one• direc-
tion• (in• the• direction• of• the• pile)• with• slight•
pressure.

•

To• avoid• appearance• of• glossy• spots• on• syn-
thetic•and•silk•fabrics,•iron•them•backside.

SET TING THE IRONING TEMPERATURE

•

Place•the•iron•on•its•base•(9).

•

Insert•the•power•plug•into•the•mains•socket.

•

Turn• the• knob• (11)• to• set• the• required• iron-
ing• temperature:• “

•

”,• “

••

”,• “

•••

”• or• “MAX”•

(depending• on• the• type• of• fabric),• the• pilot•
lamp•(8)•will•light•up.

•

Once• the• temperature• of• the• soleplate• (14)•
reaches•the•set•point,•the•pilot•lamp•(8)•will•go•
out•and•you•can•start•ironing.

Note:

If  you  are  ironing  at  high  temperature  but  you 
need to switch to low temperature, wait until the 
soleplate  temperature  decreases  and  the  pilot 
lamp(8)  lights  up,  and  only  then  you  may  start 
ironing.  While  steam  ironing  it  is  necessary  to 
set  the  ironing  temperature  “

•••

”  or  “MAX”. 

The  steam  ironing  sector  is  marked  with  corre-
sponding  symbols  on  the  temperature  control 
knob (11).

WATER SPRAY

•

You• can• dampen• the• fabric• by• pressing• the•
water•spray•button•(5)•several•times.

•

Make• sure• that• there• is• enough• water• in• the•
water•tank•(10).

DRY IRONING

•

Place•the•iron•on•its•base•(9).

•

Insert•the•power•plug•into•the•mains•socket.

•

Set• the• continuous• steam• supply• knob• (3)• to•
the•position•

•(the•steam•supply•is•off).

•

Turn• the• knob• (11)• to• set• the• required• iron-
ing• temperature:• “

•

”,• “

••

”,• “

•••

”• or• “MAX”•

(depending• on• the• type• of• fabric),• the• pilot•
lamp•(8)•will•light•up.

•

Once• the• soleplate• (14)• reaches• the• set• tem-
perature,•the•pilot•lamp•(8)•will•go•out•and•you•
can•start•ironing.

•

After• you• finish• ironing,• set• the• temperature•
control•knob•(11)•to•the•“MIN”•position.

•

Pull•the•power•plug•out•of•the•mains•socket•and•
let•the•iron•cool•down•completely.

STEAM IRONING

While•steam•ironing•it•is•necessary•to•set•the•iron-
ing•temperature•“

•••

”•or•“MAX”.

The• iron• is• provided• with• an• anti-drip• valve• that•
stops• water• supply• if• the• iron• soleplate• tempera-
ture• is• too• low;• it• prevents• dripping• from• the• iron•
soleplate•openings•(14).•During•heating•and•cool-
ing• of• the• iron• soleplate,• you• will• hear• character-
istic•clicks•of•the•anti-drip•valve•opening/closing,•
which•indicates•its•normal•operation.

•

Place•the•iron•on•its•base•(9).

•

Set• the• continuous• steam• supply• knob• (3)• to•
the•position•

(the•steam•supply•is•off).

•

Insert•the•power•plug•into•the•mains•socket.

•

Make• sure• that• there• is• enough• water• in• the•
water•tank•(10).

•

Turn• the• knob• (11)• to• set• the• required• ironing•
temperature:• “

•••

”• or• “MAX”,• the• pilot• lamp•

(8)•will•light•up.

•

Once• the• soleplate• (14)• reaches• the• set• tem-
perature,•the•pilot•lamp•(8)•will•go•out•and•you•
can•start•ironing.

•

Turn• the• continuous• steam• supply• knob• (3)•
to• set• the• steam• generation• rate,• steam• will•
start•going•out•from•the•soleplate•(14)•open-
ings.

•

After• you• finish• ironing,• set• the• temperature•
control•knob•(11)•to•the•“MIN”•position,•and•the•
continuous•steam•supply•knob•(3)•to•the•posi-
tion•

•(steam•supply•is•off).

•

Pull•the•power•plug•out•of•the•mains•socket•and•
let•the•iron•cool•down•completely.

•

Open• the• water• inlet• lid• (2),• turn• over• the• iron•
and•drain•any•remaining•water.

AT TENTION!

If  steam  is  not  supplied  constantly  during  the 
operation, check whether the temperature control 
knob (11) and the continuous steam supply knob 
(3) are set properly and whether there is water in 
the water tank (10).

BURST OF STEAM

The• burst• of• steam• function• is• useful• for• ironing•
folds• and• can• only• be• used• at• high• ironing• tem-
peratures•(when•the•iron•temperature•control•knob•
(11)•is•set•to•the•position•“

•••

”•or•“MAX”).

•

When• pressing• the• burst• of• steam• button• (4)•
steam• will• go• out• of• the• iron• soleplate• more•
intensively.

Note: 

To  avoid  water  leakage  from  steam  openings, 
press the burst of steam button (4) with a 4-5 sec. 
interval.

IM VT-1262.indd   6

10.06.2016   11:47:56