Утюги VITEK VT-1219 VT - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
8
ENGLISH
TECHNICAL SPECIFICTAIONS
Power supply: 220-240 V ~ 50 Hz
Maximal power consumption: 2200 W
The manufacturer preserves the right to
change the specifications of the unit without a
preliminary notification.
Unit operating life is 3 years
Guarantee
Details regarding guarantee conditions can be
obtained from the dealer from whom the appli-
ance was purchased. The bill of sale or receipt
must be produced when making any claim under
the terms of this guarantee.
This product conforms to the EMC-
Requirements as laid down by the
Council Directive 89/336/EEC and to
the Low Voltage Regulation (73/23 EEC)
Failure
Possible Cause
Troubleshooting
The iron is connected
to the mains, but the
soleplate doesn't heat
up
The socket doesn't work.
Plug the unit into another
socket.
Connection problem
Check if the plug is inserted
into the socket correctly.
The temperature control knob (7) is
set to the position «MIN».
Set the required temperature
using the knob (7)
The steam doesn't go
out of the soleplate
openings
Not enough water in the tank
Add water
The continuous steam supply knob (3)
is set to the position « ».
Set the knob (3) to the position
«
»
No burst of steam
Not enough water in the tank
Add water
The iron is used for the first time
Press the burst of steam
button (1)
No water from the
water spray (4)
Not enough water in the tank
Add water
The iron is used for the first time
Press the water spray button
(2)
The soleplate doesn't
heat up to the required
temperature
Wrong temperature setting
Use the temperature control
knob (7) to set the required
temperature for the particular
fabric
Water leaks from the
soleplate openings
The iron didn't heat enough for steam
release.
Set the ironing temperature
in the steam operation zone
(•••) or «MAX».
Steam supply knob (3) was set to the
position
during filling the water
tank with water.
Set the continuous steam
supply knob to the position « »
(steam supply is off).
The iron damages
fabric
Overheating
Select the ironing temperature
required for this type of fabric
Scale particles and
additions go out
through the soleplate
openings during the
ironing
You might have used hard water that
caused scale formation.
Follow the instructions given in
the chapter "Steam chamber
cleaning"
VT-1219.indd 8
31.07.2012 11:23:00
