Russell Hobs 27220-56 - Инструкция по эксплуатации - Страница 4

4

BEFORE USING FOR THE FIRST TIME

• 

Remove labels, stickers and packaging from the appliance.

• 

Read all instructions and warnings.

IMPORTANT INFORMATION

• 

For best performance, we recommend using distilled, purified or filtered water in your steamer. Tap 
water contains minerals that can build up inside your steamer over time and reduce its efficiency or 

even cause damage.

• 

Never use perfumes, oils or other additives.

• 

Always check the garment’s care label before steaming, and always test fabrics for colourfastness in 

an inconspicuous area. Steamers are not recommended for use on leather, suede, vinyl, plastic, or 
other materials that are sensitive to steam.

• 

During use the steamer and accessories will become HOT. Never try to fit or remove attachments 
while still hot.

• 

After preheating, prime the water pump by holding the steam trigger until steam forms.

• 

It is normal to feel or hear the water pump inside the device. It may become louder when the water 
level in the tank is low. Check and refill the tank when required.

• 

Small amounts of dripping might occur during use. If excessive, your steamer needs time to get back 
up to full temperature. Just allow the steamer a minute to reheat.

• 

Wearing clothes immediately after ironing or steaming can actually create wrinkles. Always allow the 

clothing to cool for about 5 minutes before wearing.

ATTACHMENTS

Your steamer has three attachments:

Lint attachment

Use on garments labelled  

k l

 that allow the use of steam.

Tip: The pad on the attachment helps remove lint, hair, and animal fur.

Delicate fabric attachment

Use on garments labelled  

j

 that allow the use of steam. 

Tip: For items with printing/embellishment, turn the garment inside out to 

avoid damage to sensitive areas.

Upholstery attachment

Use to sanitise and refresh bedding, mattresses, curtains, plush toys, 

furniture, and hard surfaces (such as worktops or desks that are not heat 

sensitive).
Always test for colourfastness and heat sensitivity on an inconspicuous 
area.

Fitting/Removing (Fig. A)

1. 

Make sure that the steamer and attachment are cool.

2. 

Hook the top of the attachment over the top edge of the steamer. Click the bottom edge into place. 
Make sure it is fully fitted and not loose or it may detach itself during use.

3. 

Remove the attachment using the tab. When removing the attachment, watch out for condensation 
that may have built up during use.

FILLING

1. 

Place the steamer on its base on a stable surface.

2. 

Pull out the removable water tank (Fig. B)

3. 

Gently open the rubber cover at the top of the tank. 

4. 

Fill until the water reaches the “MAX” level mark on the side of the tank (Fig. C). Do not overfill. Close 
the rubber cover securely.