Утюги Elenberg SI-3025 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
14
• Put the plug in the socket.
• Adjust the thermostat knob (11) according to the international
symbol on the garment label [Fig. 3]. The plate temperature con-
trol light (9) indicates that the iron is heating up. Wait until the
plate temperature control light goes off before ironing.
WARNING:
During ironing, the plate temperature control light (9) comes on at
intervals, indicating that the selected temperature is maintained. If
you lower the thermostat temperature after ironing at a high tem-
perature, do not start ironing until the plate temperature control
light comes on again.
Selecting the steam.
The quantity of steam is regulated by the steam selector (3).
Move the steam selector to a position between minimum and
maximum depending on the quantity of steam required and the
temperature selected [Fig. 1].
WARNING:
The iron gives off steam continuously only if you hold the iron
horizontally. You can stop the continuous steam by placing the
iron in a vertical position or by moving the steam selector to “0”.
As indicated on the thermostat knob (11) and in the initial table,
you can only use steam at the highest temperatures. If the se-
lected temperature is too low, water may drip onto the plate.
Selecting Shot-steam and steam when ironing vertically.
Press the shot-steam button (5) to generate a powerful burst of
steam that can penetrate the fabrics and smooth the most difficult
and tough creases. Wait for a few seconds before pressing again
[Fig. 4].
By pressing the shot-steam button at intervals you can also iron
vertically (curtains, hung garments, etc.) [Fig. 5].
WARNING:
The shot-steam function can only be used at high temperatures.
Stop the emission when the plate temperature control light (9)
comes on, than start ironing again only after the light has gone
off.
DRY IRONING
To iron without steam, follow the instructions in section “steam
ironing”, leaving the steam selector (3) on position “0”.
Spray Function
Make sure that there is water in the reservoir. Press the spray but-
ton (4) slowly (for a dense spray) or quickly (for a vaporized spray)
[Fig. 6].
