BRAYER BR4004 - Инструкция по эксплуатации - Страница 4

4

EN

SAFETY MEASURES AND OPERATION 

RECOMMENDATIONS 
Read the operation instructions carefully before 

using the iron, after reading keep them for future 

reference.

• 

Use the unit for its intended purpose only, as it is 

stated in this manual.

• 

Mishandling the iron can lead to its breakage and 

cause harm to the user or damage to the user’s 

property, which is not covered by warranty.

• 

Make sure that the operating voltage of the unit 

indicated on the label corresponds to your home 

mains voltage. 

• 

The power cord is equipped with a «euro-plug»; 

insert it into a socket that has a reliable grounding 

connection. In case of short circuit the grounding 

reduces the risk of electric shock.

• 

Contact an electrical technician, if you are not 

sure that your sockets are installed properly and 

grounded.

• 

To avoid fire, do not use adapters for connecting the 

unit to the mains.

• 

To avoid mains overloading, do not switch on several 

electrical appliances with high power consumption at 

the same time.

• 

Do not touch the unit body, the power cord and the 

power plug with wet hands.

• 

Do not let the power cord be on the ironing board and 

touch  hot surfaces and sharp edges of furniture.

• 

Do not use the unit near heating appliances, heat 

sources or open flame.

• 

Do not use the unit in proximity to the kitchen sink, in 

bathrooms, near swimming pools or other containers 

filled with water.

• 

If the unit is dropped into water, unplug it 

immediately, and only then you can take the unit out 

of water. Apply to the authorized service center for 

testing or repairing the unit.

• 

•Do not use the unit in places where aerosols 

are used or sprayed, and in proximity to highly 

inflammable liquids, do not use the unit in the places 

where such liquids are stored.

• 

Do not use the unit outdoors.

• 

It is recommended not to use the unit during lightning 

storms.

• 

Protect the unit from impacts, falling, vibrations and 

other mechanical stress.

• 

Do not leave the unit unattended. During breaks 

in operation, put the iron on the base (in vertical 

position).

• 

Before plugging the unit in set the temperature 

control knob to the minimal position and switch the 

continuous steam supply off.

• 

Always switch off and unplug the iron when you do 

not use it.

• 

Fill the tank with water additionally cleaned with a