Tefal SV8011E0 - Инструкция по эксплуатации - Страница 6

6

A problem with your appliance ?

If you have any problems or queries please call our Customer Relations team first for expert help and advice

PROBLEMS

CAUSES

SOLUTIONS

Your iron is producing little or no 
steam.

You have just filled the tank or 
changed the anti-calc cartridge, or 
you have just started using it. 

Press the steam control button conti-
nuously for few minutes pointing 
it away from your linen, in order to 
prime the pump.

There is no anti calc cartridge in 
the appliance or it is not properly 
installed.

Make sure the anticalc cartridge 
is installed and locked in its com-
partment.

Steam cannot be produced at the 
temperature you have selected. 

Set the thermostat control in the 
coloured zone (••• or MAX).

The water tank is empty. 

Fill the tank. 

Water runs out of the holes of the 
soleplate.

You are using steam for the first 
time or you have not used it for 
some time.

Press on the steam control button 
away from your ironing board until 
the iron produces steam.

The setting is not correct (1 dot / 2 
dots) and the soleplate is not hot 
enough to produce steam.

Set the iron at 3 dots (••• or MAX) 
and wait for the iron thermostat light 
to go out before activating the steam 
button again.

You are performing the Anti calc 
procedure. 

It is normal that water runs out of 
the holes of the soleplate during Anti 
calc procedure.

Water streaks appear on
the linen.

Your ironing board is saturated with 
water because it is not suitable for 
use with an appliance. 

Check that your ironing board is 
suitable. We recommend that you 
use a vented/mesh type ironing 
board.

Brown streaks come through the 
holes in the soleplate and stain 
the linen.

You are using chemical descaling 
agents or additives in the water 
ironing.

Never add this type of product in 
the water tank (see “for what water 
may be used”). Contact an Approved 
Service Centre.

The soleplate is dirty or
brown and may stain the
linen.

You are ironing at too high a 
temperature.

See our recommendations regarding 
temperature control setting.

The “anti calc” indicator is flashing*.

The anti calc cartridge is no longer 
efficient. 

Replace the anti calc cartridge with a 
new one then press the reset button  
for a minimum of 3 seconds. 

The anti calc procedure must be 
performed.

See section "Anti calc" in IFU to 
perform the anti calc procedure.

The anti calc indicator is still flashing 
after replacing the cartridge. 

You have not pressed the reset 
button. 

Press the reset button until the light 
stops flashing.

The anti calc indicator is still flashing 
after performing Anti calc procedure. 

The anti calc procedure has not been 
correctly done. 

See section Anti calc" in IFU" to 
perform correctly the anti calc 
procedure.