Утюги Rowenta Focus DZ5914F1 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
4
If there is a problem?
PROBLEM
POSSIBLE CAUSE
SOLUTION
Water drips from
the holes in the
soleplate.
You are using steam while the
iron is not hot enough.
Wait until the thermostat light goes
out.
You are using the shot of steam
button too often.
Wait a few seconds between each
use of the button.
You have stored the iron
horizontally, without emptying it
and without setting it to
.
See the section "Storing your iron".
Brown streaks come
through the holes
in the soleplate and
stain the linen.
You are using ironing water
additives (i.e. scented water,
starch).
Never use ironing water additives;
these will permanently damage your
steam iron.
You are not using the right type
of water.
Perform a Self cleaning operation
and consult the chapter "What
water should I use?".
Your linen has not been rinsed
sufficiently or you have ironed a
new garment before washing it.
Make sure that your laundry is rinsed
sufficiently in order to remove any
deposits of soap or chemical products on
new clothes.
The soleplate is
dirty or brown and
can stain the linen.
Your are ironing with an
inappropriate temperature
selection (temperature too high).
Clean the soleplate (refer to chapter
11). Select the appropriate program.
You have ironed over a printed
are of a garment.
Never iron over printed areas or
applications – always iron the
reverse side of such a garment.
There is little or no
steam.
The water tank is empty.
Fill the water tank.
Your iron has been used dry for
too long.
Carry out a Self clean.
The soleplate is
scratched or
damaged.
You have placed your iron flat
on a metallic rest-plate or ironed
over a zip.
Refrain from ironing over metallic
buttons or zippers.
Steam or water
come from the iron
as you finish filling
the tank.
The steam control is not set to
the
position.
Check that the steam control is set
to the
position.
The water tank is overfilled.
Never exceed the Max level.
The spray does not
spray.
The water tank is not filled
enough.
Fill up the water tank.
1103913613-03 IRONS SAFETIES ROWENTA F1_110x154 09/05/2016 15:01 Page4
