Philips GC9415 - Инструкция по эксплуатации - Страница 8

10

Problem 

Cause 

Solution

Water leaks from the 
soleplate.

Steam condenses into water in the 
hose when you use steam for the 
first time or have not used it for a 
long time.

This is normal. Hold the iron away 
from the garment and press the 
steam trigger.Wait until steam 
instead of water comes out of the 
soleplate.

The ironing board cover 
becomes wet, or there 
are water droplets on the 
floor/garment.

Steam has condensed on the ironing 
board cover after a long ironing 
session, or your board cover is not 
designed to cope with the high 
steam rate.

Replace the ironing board cover 
if the foam material has worn out. 
We also advise you to use a layer 
of felt material in the board cover 
to prevent water droplets.

The surface under the 
base of the appliance 
becomes wet, or steam 
and/or water comes out 
from under the EASY DE-
CALC knob.

The EASY DE-CALC knob is not 
tightened properly.

Switch off the appliance and 
wait 2 hours for it to cool down. 
Unscrew and reattach the knob to 
make sure it is tightened.

The rubber sealing ring of the EASY 
DE-CALC knob is worn.

Contact an authorized Philips 
service center for a new EASY DE-
CALC knob.

The iron does not heat up 
and the amber DE-CALC 
light flashes.

The appliance reminds you to 
perform the descaling procedure. 
The light flashes after approximately 
one month of use.

Perform the descaling procedure, 
following the instructions in 
section ‘Descaling the appliance’.

The steam generator 
produces a loud pumping 
sound. 

There is not enough water in the 
water tank.

Fill the water tank up to the MAX 
indication and press the steam 
trigger.

Warranty and support

If you need information or support, please visit 

www.philips.com/support 

or read the international 

warranty leaflet.

English