Philips GC8320/02 - Инструкция по эксплуатации - Страница 16

Problem

Cause

Solution

Steam escapes from 
under the Calc-
Clean rinsing cap 
when the appliance 
heats up.

You have not tightened the Calc-clean 
rinsing cap properly.

Switch off the appliance, tighten 
the Calc-Clean rinsing cap and 
switch on the appliance again. If 
steam continues to escape when 
the appliance is heating up, switch 
off the appliance and contact a 
ser vice centre authorised by Philips.

The iron does not 
produce enough 
steam/the amount 
of steam decreases 
and increases during 
steam ironing.

When the appliance pumps water into 
the steam generator, the steam amount 
sometimes decreases. This is probably 
when you think that the iron does not 
produce enough steam. However, this is 
a normal phenomenon and the steam 
output normalises within a few seconds.

To optimise the steam output, 
release the steam lock when you do 
not need steam and when you put 
down the iron.

Wet spots appear 
on the fabric during 
ironing.

The wet spots that appear on the fabric 
after you have steam ironed for some 
time may be caused by steam that has 
condensed onto the ironing board. Iron 
the wet spots without steam for some 
time to dr y them. If the underside of the 
ironing board is wet, wipe it with a piece 
of dr y cloth.

To prevent steam from condensing 
onto the ironing board, use an 
ironing board with a wire mesh top.

Water droplets 
come out of the 
soleplate when I use 
the shot-of-steam 
function.

Steam may have condensed in the hose, 
the temperature may have been set below 

3

 or the appliance may not be ready 

for steam ironing.

Make sure the temperature is set 
to 

3

 or higher. Steam iron for 

a few seconds before you use the 
shot-of-steam function.

ENGLISH

16